User manual BLACK & DECKER HP126FSC

[. . . ] HP126FSC HP126F2K HP128F2K HP146F2K HP148F2K HP188F2K 1 Copyright Black & Decker 2 5 6 4 3 2 1 10 8 7 9 13 12 11 A 3 10 9 17 15 16 B C 19 4 18 19 20 21 D 4 13 12 23 9 11 22 E F 3 2 24 G H 5 5 I 6 ENGLISH CORDLESS DRILL/SCREWDRIVER HP126FSC/HP126F2K/HP128F2K/ HP146F2K/148F2K/HP188F2K CONGRATULATIONS!You have chosen a Black & Decker tool. Our aim is to provide quality tools at an affordable price. We hope that you will enjoy using this tool for many years. [. . . ] N If the supply cord is damaged, it must be replaced by the manufacturer or an authorised Black & Decker Service Centre in order to avoid a hazard. Additional safety instructions for drill/screwdrivers N Before drilling into walls, floors or ceilings, check for the location of wiring and pipes. N Avoid touching the tip of a drill bit just after drilling, as it may be hot. 9 ENGLISH ELECTRICAL SAFETY Your charger has been designed for a specific mains voltage. Always check that the mains voltage corresponds to the voltage on the rating plate. Your charger is double insulated in accordance with EN 60335; therefore no earth wire is required. A) Variable speed switch Forward/reverse slider Mode selector / torque adjustment collar Chuck Two-gear selector Battery charge indicator (HP128F2/HP148F2/HP188F2) 7. ASSEMBLY Mains plug replacement (U. K. & Ireland only) N N N N N N N Should your mains plug need replacing and you are competent to do this, proceed as instructed below. If you are in doubt, contact an authorised repair agent or a qualified electrician. Disconnect the plug from the supply and remove the fuse from the plug. Cut off the plug and dispose of it safely; a plug with bared copper conductors is dangerous if engaged in a live socket outlet. Only fit 13 Amperes BS1363A approved plugs fitted with a 5 A fuse (1). The cable wire colours, or a letter, will be marked at the connection points of most good quality plugs. Attach the wires to their respective points in the plug (see above). Brown is for Live (L) (2), blue is for Neutral (N) (4). Before replacing the top cover of the mains plug ensure that the cable restraint (3) is holding the outer sheath of the cable firmly and that the leads are correctly fixed at the terminal screws. If the plug has a fuse cover, make sure that the fuse cover is fitted. Do not use the plug if the fuse cover is missing or damaged. Fitting and removing the battery (fig. B) N To fit the battery (9), line it up with the receptacle on the tool. Slide the battery into the receptacle and push until the battery snaps into place. N To remove the battery, push the release button (10) while at the same time pulling the battery out of the receptacle. Fitting and removing a drill bit or screwdriver bit (fig. [. . . ] N To switch the tool on, press the switch (1). The tool speed depends on how far you press the switch. N To switch the tool off, release the switch. N N Unplug the charger before cleaning it. Regularly clean the ventilation slots in your tool and charger using a soft brush or dry cloth. [. . . ]