User manual BLACK & DECKER HP96K

[. . . ] HP96K HP12K(D) HP14K(D) HP122K(D) HP142K(D) 1 Copyright Black & Decker 2 4 5 6 7 3 2 1 8 11 10 9 15 14 12 13 A 3 10 9 18 16 17 B 11 C 15 14 9 13 9 12 D 4 E 20 19 2 F G 5 I 3 21 22 H J 5 23 24 K 6 ENGLISH CORDLESS DRILL/SCREWDRIVER HP96K/ HP12K(D)/HP14K(D)/HP122K(D)/HP142K(D) CONGRATULATIONS!You have chosen a Black & Decker tool. Our aim is to provide quality tools at an affordable price. We hope that you will enjoy using this tool for many years. [. . . ] Always check that the mains voltage corresponds to the voltage on the rating plate. Your charger is double insulated in accordance with EN 60335; therefore no earth wire is required. 9 ENGLISH HP96K/HP12K(D)/HP14K(D) Never attempt to replace the charger unit with a regular mains plug. Two-speed on/off switch (HP96K) Forward/reverse slider Mode selector / torque adjustment collar Chuck Two-gear selector (HP122K(D)/HP142K(D)) Battery charge indicator (HP96K/HP12K/ HP14K/HP122K/HP142K) 7. Charger receptacle (HP96K/HP12K(D)/HP14K(D)) 13. Charging indicator (HP122K(D)/HP142K(D)) 15. End of charge indicator (HP122K(D)/HP142K(D)) ASSEMBLY HP122K(D)/HP142K(D) - Mains plug replacement (U. K. & Ireland only) N N N N N N N Should your mains plug need replacing and you are competent to do this, proceed as instructed below. If you are in doubt, contact an authorised repair agent or a qualified electrician. Disconnect the plug from the supply and remove the fuse from the plug. Cut off the plug and dispose of it safely; a plug with bared copper conductors is dangerous if engaged in a live socket outlet. Only fit 13 Amperes BS1363A approved plugs fitted with a 5 A fuse (1). The cable wire colours, or a letter, will be marked at the connection points of most good quality plugs. Attach the wires to their respective points in the plug (see above). Brown is for Live (L) (2), blue is for Neutral (N) (4). Before replacing the top cover of the mains plug ensure that the cable restraint (3) is holding the outer sheath of the cable firmly and that the leads are correctly fixed at the terminal screws. If the plug has a fuse cover, make sure that the fuse cover is fitted. Do not use the plug if the fuse cover is missing or damaged. Fitting and removing the battery (fig. B) N To fit the battery (9), line it up with the receptacle on the tool. Slide the battery into the receptacle and push until the battery snaps into place. N To remove the battery, push the release button (10) while at the same time pulling the battery out of the receptacle. Fitting and removing a drill bit or screwdriver bit (fig. A & C) This tool is fitted with a keyless chuck to allow for an easy exchange of bits. [. . . ] N Refer to the manual of the detector for further instructions. A) N Select forward or reverse rotation using the forward/reverse slider (2). N To switch the tool on, press the switch (1). 12 N Before performing any maintenance on the tool, remove the battery from the tool. Unplug the charger before cleaning it. ENGLISH N N N Regularly clean the ventilation slots in your tool and charger using a soft brush or dry cloth. [. . . ]