User manual BLACK & DECKER KA150K

[. . . ] To ensure the best results from your power tool please read these safety and usage instructions carefully. If you have any questions or queries after reading this user manual please do not hesitate to call our Service and Information Centre, whose number you will find towards the back of this user manual, or one of our Authorised Repair Agents. A list of these Agents and further information is available on the Internet at www. Om Du har några frågor beträffande innehållet i denna bruksanvisning kan du vända Dig till vår kundtjänst eller till en av oss auktoriserad serviceverkstad. [. . . ] , should not be left in the work area where dust could settle on them. ENVIRONMENTAL SAFETY Paint should be removed in such a manner as to minimise the amount of dust generated Areas where paint removal is occurring should be sealed with plastic sheeting. Sanding should be done in a manner to reduce tracking of paint dust outside the work area. CLEANING AND DISPOSAL All surfaces in the work area should be vacuumed and thoroughly cleaned daily for the duration of the sanding project. Vacuum filter bags should be changed frequently. Items of clothing, dust sheets, toys, washable furniture and utensils should be washed thoroughly before being used again. This means that all the external metal parts are electrically insulated from the mains power supply. This is done by placing insulation barriers between the electrical and mechanical components making it unnecessary for the tool to be earthed. Note: Double insulation does not take the place of normal safety precautions when operating the tool. The insulation system is for added protection 20 against injury resulting from a possible electrical insulation failure within the tool. ELECTRICAL SAFETY Be sure the supply is the same as the voltage given on the rating plate. the tool is fitted with a two-core cable and plug. MAINS PLUG REPLACEMENT (UK ONLY) Should the mains plug need replacing and you are competent to do this, proceed as instructed below. If you are in doubt, contact a Black & Decker service agent or a qualified electrician. Disconnect the plug from the power supply. A plug with bared copper conductors is very dangerous if engaged in a live socket outlet. Only fit BS1363A approved plugs fitted with the correctly rated fuse. Note: Fuses do not give personal protection against electric shock. The cable wire colours, or a letter, will be marked at the connection point of most good quality plugs. attach the wires to their respective points in the plug (see diagram). Brown is L (live) and blue is N (neutral). Fit a 5 amp fuse approved to BS1362 Connect brown to L (live) Make sure that the outer sheath of the 230 volts AC only cable is held firmly Never use a light by the clamp socket · Before replacing the top cover of the plug ensure that the cable restraint is holding the outer sheath of the cable firmly and that the two leads are correctly fixed at the terminal screws. [. . . ] PREPARING YOUR MOUSE To prepare your Mouse, proceed as follows: Disconnect the plug from the electricity supply. fit the appropriate abrasive or accessory to the base of the tool and connect the dust extraction outlet to a vacuum cleaner. USING YOUR MOUSE WITH THE POINTED BASE Your Mouse is equipped with a teardrop base which allows you to use it on large flat surfaces, as well as difficult and confined areas. fITTING THE ABRASIVE Your Mouse uses pre-cut nylon backed sheets of abrasive of a specific size. [. . . ]