User manual BLACK & DECKER KC2000

[. . . ] UK Ireland Australia New Zealand 1 11 8 7 3 10 9 3 2 1 6 4 2 1 5 5 13 14 12 6 14 13 12 A 2 3 2 6 5 6 5 B C 9 17 7 15 16 21 2 1 D E F 20 18 G 1 2 H 19 I J 22 K 3 Intended use Your Black & Decker multi-purpose tool has been designed for a wide range of DIY applications. Using the drill/screwdriver head, this tool is intended for screwdriving applications and for drilling in wood, metal, plastics and soft masonry. Using the jigsaw head, this tool is intended for sawing wood, metal and plastics. Using the sander head, this tool is intended for sanding wood, metal, plastics and painted surfaces. [. . . ] x Open the chuck by turning the front part (15) with one hand while holding the rear part (16) with the other (fig. x Insert the bit shaft (17) into the chuck. x Firmly tighten the chuck by turning the front part (15) with one hand while holding the rear part (16) with the other. This tool is supplied with a double-ended screwdriver bit in the bit holder (4) (fig. x To remove the screwdriver bit from the bit holder, lift the bit from the recess. x To store the screwdriver bit, firmly push it into the holder. F & G) x Lock the tool by setting the forward/reverse slider (2) to the centre position (fig. x To fit a saw blade, lift the lever (18) and hold it in this position (fig. x Insert the saw blade into the holder as shown. Make sure that the teeth are pointing to the front. x To remove the saw blade, lift the lever (18) and pull the saw blade from the holder. Fitting and removing sanding sheets (fig. F & I) The sanding head uses pre-cut sanding sheets. x Lock the tool by setting the forward/reverse slider (2) to the centre position (fig. x Before fitting a new sheet, remove the two additional diamond tips (20) (fig. x To fit a sanding sheet, line it up with the sanding base as shown. x Press the sheet firmly and evenly onto the sanding base, making sure that the holes in the sheet coincide with the holes in the base. x To remove the sheet, pull it off the sanding pad. Assembly Warning!Before assembly, remove the battery from the tool. B) KC2000 x To fit the battery (5), line it up with the receptacle on the tool. Slide the battery into the receptacle and push until the battery snaps into place. x To remove the battery, push the two release buttons (6) simultaneously while at the same time pulling the battery out of the receptacle. [. . . ] Batteries Black & Decker batteries can be recharged many times. At the end of their useful life, discard Cd batteries with due care for our environment: x Run the battery down completely, then remove it from the tool. x NiCd and NiMH batteries are recyclable. Take them to any authorised repair agent or a local recycling station. [. . . ]