User manual BLACK & DECKER KG 725

[. . . ] We hope that you will enjoy using this tool for many years. EC DECLARATION OF CONFORMITY KG68/KG70/KG75/CD500 Black & Decker declares that these products conform to: 98/37/EC, 89/336/EEC, 73/23/EEC, EN 50144, EN 55014, EN 61000 Level of sound pressure, measured according to EN 50144: INTENDED USE Your Black & Decker angle grinder has been designed for cutting metal and masonry using the appropriate type of cutting or grinding disc. It is also suitable for sanding using a backing pad and sanding disc. This tool is intended for consumer use only. [. . . ] x Thoroughly remove all dust after sanding. X Take special care when sanding paint which is possibly lead based or when sanding some woods and metal which may produce toxic dust: - Wear a dust mask specifically designed for protection against lead paint dust and fumes and ensure that persons within or entering the work area are also protected. 8 x x Should your mains plug need replacing and you are competent to do this, proceed as instructed below. If you are in doubt, contact an authorised repair agent or a qualified electrician. Disconnect the plug from the supply and remove the fuse from the plug. Cut off the plug and dispose of it safely; a plug with bared copper conductors is dangerous if engaged in a live socket outlet. Only fit 13 Amperes BS1363A approved plugs fitted with the correctly rated fuse (1). The cable wire colours, or a letter, will be marked at the connection points of most good quality plugs. Attach the wires to their respective points in the plug (see above). Brown is for Live (L) (2), blue is for Neutral (N) (4). Before replacing the top cover of the mains plug ensure that the cable restraint (3) is holding the outer sheath of the cable firmly and that the leads are correctly fixed at the terminal screws. If the plug has a fuse cover, make sure that the fuse cover is fitted. P65 8 17-07-2001, 14:51 ENGLISH Do not use the plug if the fuse cover is missing or damaged. fitting and removing the guard Fitting (fig. B) x Place the tool on a table, with the spindle (6) facing up. X Hold the guard (4) over the tool as shown. X Press the guard down (A) and turn it counterclockwise (B). C) x While holding the tool, turn the guard (4) clockwise. x Use a screwdriver to press down the locking pin (9). X Release the guard and take it off the tool. Never use the tool without the guard, except when sanding. Using an extension cable Always use an approved extension cable suitable for the power input of this tool (see technical data). [. . . ] X Place the outer flange (12) onto the spindle with the raised centre facing away from the disc. X KG68/CD500: Hold the spindle using the wrench (13) and tighten the outer flange using the two-pin spanner (14) (fig. X KG70/KG75: Keep the spindle lock (3) depressed and tighten the outer flange using the two-pin spanner (14) (fig. X To switch off, press the rear part of the on/off switch. [. . . ]