User manual BLACK & DECKER KR500

[. . . ] ;; AST1 CD200 CD501 KR400 KR420 KR450 KR500 KR502 KR510 KR531 KR532 1 Copyright Black & Decker 2 6 7 y @ ; yy y ;; ; ;; 3 4 5 1 2 3 A 5 9 y @ ; C 14 15 13 11 10 12 B 12 16 D 4 E ENGLISH DRILL AST1/CD200/CD501/KR400/KR420/ KR450/KR500/KR502/KR510/KR531/KR532 CONGRATULATIONS!You have chosen a Black & Decker tool. Our aim is to provide quality tools at an affordable price. [. . . ] Repairs This tool complies with relevant safety requirements. Repairs should only be carried out by qualified persons using original spare parts; otherwise this may result in considerable danger to the user. x x x Additional safety instructions for Australia and New Zealand x This appliance is not intended for use by young or infirm persons without supervision. Children must be supervised to ensure they do not play with the appliance. x If the supply cord is damaged, it must be replaced by the manufacturer or an authorised Black & Decker Service Centre in order to avoid a hazard. ELECTRICAL SAFETY The electric motor has been designed for one voltage only. Always check that the power supply corresponds to the voltage on the rating plate. This tool is double insulated in accordance with EN 50144; therefore no earth wire is required. x Only fit 13 Amperes BS1363A approved plugs fitted with the correctly rated fuse (1). The cable wire colours, or a letter, will be marked at the connection points of most good quality plugs. Attach the wires to their respective points in the plug (see above). Brown is for Live (L) (2), blue is for Neutral (N) (4). Before replacing the top cover of the mains plug ensure that the cable restraint (3) is holding the outer sheath of the cable firmly and that the leads are correctly fixed at the terminal screws. If the plug has a fuse cover, make sure that the fuse cover is fitted. Do not use the plug if the fuse cover is missing or damaged. Never use a light socket. Using an extension cable Always use an approved extension cable suitable for the power input of this tool (see technical data). Before use, inspect the extension cable for signs of damage, wear and ageing. Replace the extension cable if damaged or defective. When using a cable reel, always unwind the cable completely. Use of an extension cable not suitable for the power input of the tool or which is damaged or defective may result in a risk of fire and electric shock. OVERVIEW (fig. A) This tool includes some or all of the following features. Variable speed switch (AST1, CD501, KR450RE, KR500(C)RE, KR510) 1. Forward/reverse switch (other models) 4. Keyed chuck Mains plug replacement (U. K. & Ireland only) x x x Should your mains plug need replacing and you are competent to do this, proceed as instructed below. If you are in doubt, contact an authorised repair agent or a qualified electrician. [. . . ] x Tighten an Allen key (16) into the chuck and strike it with a hammer as shown. x Remove the chuck by turning it counterclockwise. x To refit the chuck, screw it onto the spindle and secure it with the chuck retaining screw. USE x x Let the tool work at its own pace. Before drilling into walls, floors or ceilings, check for the location of wiring and pipes. 8 ENGLISH Accessories The performance of your tool depends on the accessory used. [. . . ]