User manual BLACK & DECKER KW1600E

[. . . ] Your Black & Decker router has been designed for routing wood and wood products. This tool is intended for consumer use only. Stay alert, watch what you are doing and use common sense when operating a power tool. Do not use a power tool while you are tired or under the influence of drugs, alcohol or medication. [. . . ] If the supply cord is damaged, it must be replaced by the manufacturer or an authorised Black & Decker Service Centre in order to avoid hazard. Take special care when routing where the paint is possibly lead based or when routing some woods which may produce toxic dust: - Do not let children or pregnant women enter the work area. - Do not eat, drink or smoke in the work area. The declared vibration emission values stated in the technical data and the declaration of conformity have been measured in accordance with a standard test method provided by EN 60745 and may be used for comparing one tool with another. The declared vibration emission value may also be used in a preliminary assessment of exposure. The vibration emission value during actual use of the power tool can differ from the declared value depending on the ways in which the tool is used. The vibration level may increase above the level stated. When assessing vibration exposure to determine safety measures required by 2002/44/EC to protect persons regularly using power tools in employment, an estimation of vibration exposure should consider, the actual conditions of use and the way the tool is used, including taking account of all parts of the operating cycle such as the times when the tool is switched off and when it is running idle in addition to the trigger time. The following pictograms are shown on the tool: Warning!To reduce the risk of injury, the user must read the instruction manual. This tool is double insulated; therefore no earth wire is required. Always check that the power supply corresponds to the voltage on the rating plate. If the supply cord is damaged, it must be replaced by the manufacturer or an authorised Black & Decker Service Centre in order to avoid a hazard. On/off switch Lock-off button Handle Variable speed control knob Plunge lock lever Spindle lock button Collet Revolver depth stop Depth stop bar Chip deflector Dust extraction adaptor Fit the distance piece (14) to the base of the router using the screws provided. Fit the centring pin (15) to the workpiece side of the edge guide with the screw (25) provided. Fit the `L' bar (16) to the upper side of the edge guide using the two screws and nuts provided. Before assembly, make sure that the tool is switched off and unplugged. Remove the chip deflector (10) by pulling it straight up from the router base. Keep the spindle lock button (6) depressed and rotate the spindle until the spindle lock fully engages. Make sure that the shank protrudes at least 3 mm from the collet as shown. Keep the spindle lock button (6) depressed and tighten the collet nut (17) using the spanner provided. The additional guide (21) is designed to allow routing of a thin piece of wood (e. [. . . ] You can use the tool without a guide (fig. Refer to the table below for common types of router bits. Should you find one day that your Black & Decker product needs replacement, or if it is of no further use to you, do not dispose of it with household waste. make this product available for separate collection. [. . . ]