User manual BLACK & DECKER KW850E

[. . . ] We hope that you will enjoy using this tool for many years. EC DECLARATION OF CONFORMITY INTENDED USE Your Black & Decker router KW850E has been designed for routing wood and wood products. This tool is intended for consumer use only. Level of sound pressure, measured according to EN 50144: Warning symbols The following symbols are used in this manual: Denotes risk of personal injury, loss of life or damage to the tool in case of nonobservance of the instructions in this manual. [. . . ] - Do not let children or pregnant women enter the work area. - Do not eat, drink or smoke in the work area. Additional safety instructions for Australia and New Zealand x This appliance is not intended for use by young or infirm persons without supervision. Children must be supervised to ensure they do not play with the appliance. X If the supply cord is damaged, it must be replaced by the manufacturer or an authorised Black & Decker Service Centre in order to avoid a hazard. Should your mains plug need replacing and you are competent to do this, proceed as instructed below. If you are in doubt, contact an authorised repair agent or a qualified electrician. Disconnect the plug from the supply and remove the fuse from the plug. Cut off the plug and dispose of it safely; a plug with bared copper conductors is dangerous if engaged in a live socket outlet. Only fit 13 Amperes BS1363A approved plugs fitted with the correctly rated fuse (1). The cable wire colours, or a letter, will be marked at the connection points of most good quality plugs. attach the wires to their respective points in the plug (see above). Brown is for Live (L) (2), blue is for Neutral (N) (4). Before replacing the top cover of the mains plug ensure that the cable restraint (3) is holding the outer sheath of the cable firmly and that the leads are correctly fixed at the terminal screws. If the plug has a fuse cover, make sure that the fuse cover is fitted. Do not use the plug if the fuse cover is missing or damaged. Using an extension cable Always use an approved extension cable suitable for the power input of this tool (see technical data). Before use, inspect the extension cable for signs of damage, wear and ageing. replace the extension cable if damaged or defective. When using a cable reel, always unwind the cable completely. Use of an extension cable not suitable for the power input of the tool or which is damaged or defective may result in a risk of fire and electric shock. B) x Keep the spindle lock (7) depressed and rotate the spindle until the spindle lock fully engages. [. . . ] Refer to the table below for common types of router bits. N) The distance piece can be used for trimming wooden or laminate vertical projections. O) The centring pin can be used to cut out circular patterns. X The router can now be moved over the workpiece to cut out the circle. [. . . ]