User manual BLAUPUNKT ACD 2900

[. . . ] FAD ­ Adjustment of the front/rear volume via buttons </> 7. 3 FM·T button (Frequency Modulation) FM button This button is used for shifting between the different individual FM storage levels and T (Travelstore). 4 ARI button Use this button to activate the ARI function. 5 MIX·lo·m button CD: Use this button to play the CD titles in an arbitrary order. [. . . ] 18 Traffic safety has always priority. Use your car radio in such a manner that you are always able to cope with and react to the prevailing traffic situation at any given time. Remember, even at 50 km/h you are still moving at a speed of 14 m per seconds. It is also very important that you are able to hear, and react to, acoustic warning signals around you, for example from the police or the firebrigade. Therefore, adjust the volume reasonably. FRANÇAIS CD Section . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 18 Traffic safety ENGLISH DEUTSCH Contents Important information Anti-theft coding To listen to the radio or cassette again, · insert the set into the compartment until it stops and move the handle back to the front panel. If the coding system is off, your set will be ready for operation. If the coding system is on, proceed as described under "Restart following interruption of power supply". The car radio comes standard with the code system deactivated. If the anti-theft coding system is on while the power supply to the unit is interrupted (e. g. theft, disconnecting the car battery), the set is electronically blocked. - Press preset button 2 five times, "500" appears in the display. - Press preset button 3 twice, "520" appears in the display. - Press preset button 4 once, "521" appears in the display. To confirm the code number: Press the upper part of the rocker switch . Now it is essential to enter the correct code after the waiting period has elapsed (Cod in the display). If the radio is turned off before the waiting period has elapsed, then the waiting period restarts as soon as the radio is turned on again. ON/OFF To switch on the set: · Turn button 1 clockwise. To switch off the set: · Turn button 1 counterclockwise. Switching the code system off · · · · Turn off the radio. Simultaneously press preset buttons 1 and 4 and hold them down. "Cod" will appear in the display. · · Your car radio is now ready for operation. If three dashes appear again in the display, you have entered a wrong code number. · 15 PORTUGUES Press rocker switch </> 7 on the right to boost the high frequencies or on the left for treble reduction. The number on display 9 changes between -7 and +7. ESPAGÑOL SVENSKA Enter the code number given in the Blaupunkt car radio passport and confirm: See example "Restart following interruption . . . ". The code system is now deactivated. Treble Control To adjust the high frequencies: · Press the AUD button 2 until tre and a number between -7 and +7 appears on the display. NEDERLAND Press rocker switch </> 7 on the right to boost the bass frequencies or on the left for bass reduction. [. . . ] Note: If you tune to an FM station already stored on the storing levels FM or Travelstore, the coresponding storing level and the preset button will flash in the display. Switching Traffic Messages On and Off The ARI function is switched on by pressing the ARI button 4. Display 9 c will then give you the "ARI" indication. When listening to a station without the ARI identification, an audible alarm tone will be produced after approximately 3 seconds. Acoustic Alarm When leaving the coverage area of the tuned in station, your car radio automatically sends out an acoustic alarm after approximately 30 seconds. [. . . ]