User manual BLAUPUNKT ACR 4231 QO

[. . . ] 13 Insert cassette tape . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13 Remove cassette tape . . . . . . . . . . . . . . . . . . . . . . . . . . 13 Fast forward . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13 Fast rewind . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Recall "T": Press FM·T until T appears in the display. Then press the station button quickly and repeatedly if necessary. = TREB (treble) For adjusting the treble > BASS For adjusting the bass 3 Cassette tape slot 4 FR (Fast Rewind): Rewinds tape quickly to the beginning. 5 PROG (Autoreverse) To switch over to the other tape track press both buttons. 6 FF (Fast Forward) Forwards tape quickly to the end. 8 Station selection automatic or manual ("m" in display). Switch over by pressing lo · m 9 9 lo · m Io lit up in the display indicates normal sensitivity for the station search function. Io not lit up in the display indicates high sensitivity for the station search function. m lit up indicates manual station fine tuning. 10 Station search m should not be lit up in the display. If it is, switch it off by pressing lo · m press right or left. · The car radio will automatically tune into the next station. You can store 5 stations each for AM and LW frequencies. · Select the button 1-5 to store the new station and press it. · to tune in the station you Press want to store (automatically or manually). · Stereo - mono switch If you would like to switch between stereo and mono reception: · Press lo · m for approximately 2 seconds. During stereo reception the stereo symwill light up in the display. bol Each time the car radio is switched on, the reception will automatically be set to stereo. The radio will automatically switch to mono when the reception conditions are poor. Press the button 1-5 and hold it. First the station will be muted and then become audible again. The station has been stored in the memory bank. The corresponding memory bank and the button preset will appear in the display. Note: If you tune into a station which has already been stored, then the corresponding button preset and the memory bank will flash in the display for approximately 5 seconds. Recalling stored stations You can recall the stored stations by pressing the corresponding buttons. Press FM·T until I, II, III or T appears in the display. [. . . ] During cold weather, allow cold cassettes to warm up somewhat before playing them in order to avoid uneven tape transport. Operating problems and sound distortions may occur after approximately 100 hours of playing time and are caused by dust particles which adhere to the rubber roller pad and the tape head. Use a cleaner cassette to remove normal dirt build-up. If more dirt than usual has accumulated, use a cotton bud dipped in rubbing alcohol to clean these parts. [. . . ]