User manual BLAUPUNKT AMSTERDAM NAV35E RB

[. . . ] - When you drill holes, ensure that you do not damage any vehicle components. - If the positive and negative cable are extended, ensure that the cross section is not less than 2. - An incorrect installation can result in malfunctions of the electronic vehicle systems or your car sound system. [. . . ] When selecting the installation location, select a dry location that offers sufficient air circulation for cooling the amplifier. The THb 210A must not be installed on rear shelves, rear seats or other locations that are open to the front. The installation location must be suitable to accept the accompanying screws and provide a firm support (see page 2 / Fig. The amplifier power cable must be fitted with a fuse no more than 30 cm from the battery to protect the vehicle battery in case of a short circuit between power amplifier and battery. The fuse of the amplifier protects only the amplifier, not the vehicle battery. The following control setting is recommended as basic setting before putting the device into operation: Sensitivity (gain) pos. Until you can hear a clear amplification of the bass level. Next, use the crossover control 3 to select a filter setting that provides a well-contoured bass. you may have to alternately optimise the gain control setting 1 and the filter setting 3. The THb 210A must not be installed on rear shelves, rear seats or other locations that are open to the front. The installation location must be suitable to accept the accompanying screws and provide a firm support (see page 2 / Fig. The amplifier power cable must be fitted with a fuse no more than 30 cm from the battery to protect the vehicle battery in case of a short circuit between power amplifier and battery. The fuse of the amplifier protects only the amplifier, not the vehicle battery. The following control setting is recommended as basic setting before putting the device into operation: Sensitivity (gain) pos. Now slowly increase the gain control 1 until you can hear a clear amplification of the bass level. Next, use the crossover control 3 to select a filter setting that provides a well-contoured bass. you may have to alternately optimise the gain control setting 1 and the filter setting 3. A droning bass with excessive volume requires a filter setting with a low frequency. [. . . ] The phase switch must be set so that the bass is integrated into the acoustic pattern as best as possible and not recognisable as an individual source. Also check your settings of the THb 210A with the bass control fully open and, if necessary, with activated loudness. One of the special features of the THb 210A is its automatic switch-on. [. . . ]