User manual BLAUPUNKT AMSTERDAM NAV35E RB GG

[. . . ] Navigation Radio CD TravelPilot Amsterdam NAV 35E E TravelPilot Operating and installation instructions www. blaupunkt. com 2 Device overview 2 1 3 4 5 6 7 8 9 1 2 3 4 5 6 16 15 14 13 12 11 10 1 NAV button Short press: Activates navigation mode and the four memory banks. Long press: Opens the selection menu for traffic-jam ahead and route options. Volume control (VOL) Switches the device on/off and activates/deactivates the mute volume function. BAND button Short press: Activates radio mode and selects the FM, MW and LW wavebands. [. . . ] Notes: If necessary, you will be asked to insert the navigation CDROM if it is not already present in the CD drive. The system must be tuned into a TMC station during navigation in order to provide dynamic navigation. The TMC symbol flashes if the system is not tuned into a TMC station. B6, WESTSC HNELLWEG INTRODUCTION NAVIGATION RADIO CD / MP3 CD CHANGER SETUP APPENDIX 43 INTRODUCTION NAVIGATION RADIO CD / MP3 CD CHANGER SETUP APPENDIX 44 Recalculating the route If the TravelPilot receives a traffic message from the TMC that is relevant to the route, it will automatically recalculate the route. The system outputs a voice announcement informing you that the route is being recalculated. Plus Point: If the speech output for traffic announcements is activated on the TravelPilot (see "Configuring the language and speech options" in the "Setup ­ basic settings" chapter), the system will read out a detailed traffic jam announcement (if the announcement applies to the current route). Depending on the information broadcast over TMC, the TravelPilot might (but not necessarily) work out a detour. If the system does guide you through the traffic disruption despite having recalculated the route, it will inform you of this with a voice announcement telling you that the route contains traffic disruptions. Notes: If necessary, the system will ask you to insert the navigation CDROM. Tuning into TMC stations automatically If the automatic TMC feature is activated and the system did not receive a TMC station before, the tuner will automatically tune into a TMC station when you select DYNAMIC. Note: TMC seek tuning can take a long time because the system scans the entire frequency range for TMC stations. Radio mode is not available during this time. To activate the automatic TMC feature, proceed as follows: 1 2 Press the MENU button @. A selection menu appears in the display. 3 4 5 Mark and confirm the TMC AUTO menu item. Mark the ON menu item and press the OK button ;. Press the ESC button = twice to return to navigation mode. radio TMC TMC AUTO SEEK NAV Tuning into TMC stations manually To tune into a TMC station manually, proceed as follows: 1 Press the button 7 or the button 8. The radio tunes into the next receivable station. If it is a TMC station, the TMC symbol appears on the display. Reading TMC messages The TravelPilot provides you with the option of displaying the traffic messages received via TMC (Traffic Message Channel). The TMC messages are displayed sorted according to road numbers. If no messages are stored in memory, an appropriate notice will be displayed. 2 1 2 3 Turn the menu knob : to browse through the list of available messages. If a message is longer than the display area can accommodate, Turn the menu knob : to scroll through the message. [. . . ] 8 4. 3 Removing the TravelPilot Detach the control panel. You must now insert the stirrups into the designated holes on the left and right of the surround panel and push them in until you hear a clear clicking sound (side springs unlocked). Now carefully pull on the two stirrups to extract the TravelPilot. The connecting cables can now be disconnected by pressing on the sides of the clips on the respective plug-and-socket connections (see Fig. [. . . ]