User manual BLAUPUNKT ASPEN CM147

[. . . ] FCC Warning The equipment has been tested and found to comply with the limits for a Class B device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and, if not installed and used in accordance with instructions, may cause harmful interference with radio communications. However, there is no guarantee that radio interference will not occur in particular installation. [. . . ] Audio is muted during storage, preset number appears, and beep acknowledges storage. No preset storage during seek, scan or Travel Store. Preset Station Selection Press desired Preset Button. Travel Store This feature allows you to automatically store stations onto all 6 preset buttons and is especially useful when traveling outside your normal listening area. In any FM Bank, press FM Button for 2 seconds to activate FM Travel Store. (In AM Bank, press AM Button for 2 seconds to activate AM Travel Store. ) T STORE appears, followed by seek-type display of frequency and preset numbers. Beginning at the bottom of the band, TS stores six strongest stations, one on each of the six preset buttons, in decreasing order of signal strength, and returns to preset 1. Pressing any presets FM, or AM Button scan cancels search operation. When source is changed during Travel Store, operation completes itself, despite source change. "STA SCAN" appears, then frequency blinks (along with preset number if appropriate) during scanning. Unit stops at receivable stations for scan time set under Menu. Unit continuously scans until user stops scan by pressing SCA, another tuning button, SRC, or MENU button. Preset Scan Tuning Press PS/SCA for more than 2 seconds. "PS SCAN" appears, then frequency and preset number blink during scanning. Unit starts at FM1/Preset 1 (or AM/Preset 1) and proceeds through all presets (in FM all three banks) and returns to frequency tuned prior to PS activation and stops. Stops earlier if user presses another tuning button, SCA, SRC, or MENU button. Unit skips past preset frequencies that do not meet minimal seek-tuning threshold. Tuner Timer and Station Naming (See pages 20 and 21) 15 Cassette Tape Player Operation Once playback location change is complete, tape display sequence follows. Cassette Insertion & Eject "LOADING" appears upon insert and cassette play follows. "EJECT" appears and radio plays. The following indicates what happens with insert and eject under various conditions: Activity Ignition off Ignition On/ Unit Off Turns Unit On OK Ignition On/ Power On/ Non-Tape Source Tape becomes active source OK Insert Eject No Reaction OK Cassette Direction/Program Selection "TAPE 1" indicates top side of tape is in play; "TAPE 2", bottom side. Press to reverse tape direction during playback. [. . . ] To receive wireless commands, your receiver is equipped with a built-in infrared sensor (or "eye") on the faceplate. Both of remote controls have the following buttons: SRC, SCA, +/- /\, V, << and >>. You can use them to activate all of the same features as you would using the corresponding buttons on front of the unit itself. See your Blaupunkt dealer for details. 23 Troubleshooting Guide The following check will assist in the correction of most problems which you may encounter with your unit. [. . . ]