User manual BLAUPUNKT BERGAMO RCR 148

[. . . ] Be sure to observe the safety notes of the automobile manufacturer (airbags, alarm systems, on-board computers, immobilisers). Before drilling holes, look to see what is on the other side - making holes into the battery, wiring looms or fuse box is not recommended! [. . . ] Check the installation situation in the vehicle and, if necessary, use one of the special installation kits for specific vehicle models, e. Audi A4/A6/A8: 7 608 021 474 Note: The mounting bracket included with this car radio is designed for installation in vehicles with a standard DIN installation compartment measuring 182 x 53 mm, 165 installation depth and an instrument panel thickness of approximately 1 to 20 mm in the area of the tab fasteners, see Fig. Reach behind the car radio compartment and check to see which tab fasteners can be bent for the mounting bracket. 5 Positive/negative connection with connection line 7 607 884 093 . 6 Do not connect the control wire to terminal 15 (+12 V switched) or terminal 30 (permanent +12 V), maximum load < 150 mA. 7 LF = left front, RF = right front, LR = left rear, RR = right rear. If necessary, also use cables 7 607 647 093 and 7 607 648 000. Connection in vehicles with QuickOut In vehicles equipped with a QuickOut (currently Opel), the QuickOut unit must be removed and the adapter cable used. Installing the car radio Place the car radio in the front of the mounting bracket and push it in until the side springs snap into position on the left and the right (you will hear an audible click). Removing the car radio Insert the handles into the holes in the panel on the left and right of the radio and push them in until you hear a distinct click (unlocks side springs). Pull the unit out using both handles, see Fig. 3 Note: Handles which have snapped into place can only be removed after you have pulled the radio out of the compartment. [. . . ] Montering av bilradion Sätt i bilradion framifrån i hållaren och skjut in den, tills hållfjädrarna på sidorna till höger och till vänster arreteras (det hörs tydligt att det knäpper till). Demontering av bilradion Stick in byglarna till vänster och till höger i de hål som finns i panelen och tryck in dem så långt att det tydligt hörs att det knäpper till (fjädrarna på sidorna är lossade). [. . . ]