User manual BLAUPUNKT BREMEN RCM 43 FITTING INSTRUCTIONS

[. . . ] Disconnect the battery ground wire during installation and connection. This car radio can be used for both 2 x 20 or 4 x 7 watts operation. [. . . ] Remove the insulation from the ground cable and attach the forked cable lug (if necessary, solder it). Scratch off the paint from the contact area of the ground point and lubricate it with graphite grease (important for good ground contact). Connect the positive cable together with distributor to pin 30 (constant power) or pin 15 (positive line connected via ignition) of the fuse holder behind the fuse. Install the car radio into the DIN cut-out provided in your car's dashboard ex factory. Prepare the car radio DIN cut-out (unlock shelf or dummy cover) or cut out the car radio compartment to 182 x 53 mm. Grasp behind the car radio cut-out and check how many of the fixing strips of the car radio support may be bent. note: Try to bend as many fixing strips as possible. Insert the support into the cut-out and bend the appropriate fixing strips with a screwdriver, see fig. Connect the permanent plus terminal together with the cable and cable clamp to a fuse-protected positive line (e. When connecting a fully automatic motor antenna, use the cable clamp to fasten the control cable of the motor antenna to the control cable. lighting connection (Illumination) Lighting connection for vehicles with adjustable dashboard lighting (pluscontrolled). Telephone mute (Low) If you have connected a car telephone, your car radio will be mutet during telephone calls. [. . . ] Telephone Mute Quando o telephone chama ou entra em funcionamento, o som do aparelho é cortado automaticamente. / For further connection configurations with other amplifiers, equalizer / amplifier or subwoofing, please contact your dealer! [. . . ]