User manual BLAUPUNKT CHARLOTTE CR148

[. . . ] ilh Eade~ III-US Taaer Rtfeeptear/l ecterrr Cassette arec S~a~aaisear Cadelra III-US ~ece~~a~/~e ~adac~a~ de Casse~ie son Sia~aaizada~ Cadet 11/Tact-fifas ~ece~~ar cam Sia~aaizada~ Cadet ~~I-~ Bosch Group FCC Warning The equipment has been tested and found to comply with the limits for a Class B device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and, if not installed and used in accordance with instructions, may cause harmful interference with radio communications. However, there is no guarantee that radio interference will not occur in particular installation. [. . . ] Connect the yellow (constant power) input lead to a source of constant battery power, preferably a terminal to an appropriate slot in the fuse box. Connect the red (turn-on power) input lead only after the other leads are connected. Be sure to connect the red lead to a positive (+) 12 Volt power terminal that is energized only when the ignition key is set to the on position or accessory position. Cover the ends of any unused leads with electrical tape. This will prevent them from touching the vehicle or each other and causing a short-circuit and damage to the radio or vehicle. Once the connections have been successfully made, you can begin to mount the unit. 2. SPEAKER CONNECT;ONS The unit's Dual-Level Fader allows you to fade between the front and the rear channels using either the front and/or rear speaker leads and/or the rear preamp outputs, providing you tremendous flexibility in configuring your speaker arrangement: You can connect a speaker (regular, co-axial or tri-axial speakers or component speaker system, all hereafter referred to simply as "speaker") to each of the units' four pairs of speaker leads. You can connect the 2 RCA preamp outputs to multiple external amplifiers and power multiple speakers or speaker systems through the amplifiers. (Blaupunkt amplifiers and speakers available separately). To add front preamp output, purchase Blaupunkt part 8634494218. You can use a combination of these two methods. Connecting the Speaker Leads To prevent short circuits or serious damage to the unit and/oi speakers: l Connect the speaker leads only as indicated in the wiring diagram. Disconnect the vehicle battery's negative terminal before making connections. Make sure the unit is firmly anchored (preferably at both front and back) and does not vibrate. Mounting Hardware Sleeve Mounting Strap and Screw (3) Release Keys Mounting The Unit in Most Dashboards 1 Install the Sleeve (1) in the dashboard. 2 Select and bend the appropriate tabs to hold the sleeve firmly in place. Attach the Mounting Strap (2) to the underside of the dashboard, using screw. Attach the back of the unit to the mounting strap using the support stem bolt and hardware. 8 . You may have difficulty mounting this unit in some Japanese cars that have IS0 mounting features. In this case, consult your Blaupunkt dealer. 1 Run a blade along the slits on the back of the front trim ring, unscrew the two side screws, and separate it from the unit. Save the trim ring and related hardware in case you ever want to install the unit in another vehicle. 2 Use the vehicle's own mounting hardware to attach the unit. Mounting the Unit in a Japanese Car 1 Slit 2 TOYOTA max. [. . . ] If uit is turned on, EJ will appear in the display for 2 seconds and the last-heard radio station will play. Automatic Change (Autoreverse): When the end of the tape is reached, the unit will l automatically reverse direction and play the other side of the tape. Manual Change: To manually reverse tape direction, press both PROG (program) Buttons (FR l & FF) at the same time. The change in direction and in tape program will be confirmed in the display ("1" or "2"). [. . . ]