User manual BLAUPUNKT CLUB GTI FLEX A-RT 07-M INSTALLATION INSTRUCTION

[. . . ] 68 Receiving traffic programme stations with RDS-EON. . . . . . . . . . . . . . . . 72 Traffic announcement priority on/off . . . . 72 Beep tone . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 72 Switching off the beep tone . . . . . . . . . . . . . . . [. . . ] With the Cleveland DJ A you can also use BND to switch over to medium-wave (M) or long-wave (L). To switch over: Press BND as often as required. The selected mode appears in the display. TS - Travelstore To store and recall the five most powerful stations with Travelstore. To store: Press button for approximately 1 sec. until you hear a beep and "T-STORE" appears in the display. To recall: Select the memory bank "T" and press the corresponding preset button (1 - 5) briefly. 66 : Display a ; Reversing the tape/fast winding Reversing the tape Press FR and FF buttons at a time. "TR1" or "TR2" will appear. b Fast winding FR: Fast rewind - press FF to stop. FF: Fast forward - press FR to stop. m a) b) c) d) e) f) g) h) i) NDR 3 TR 1 CD 9 FM l, II, T 4 LD lo AF Station name Track (side) 1 of the cassette CD number in changer mode Waveband Memory bank I, II or Travelstore Preset button (1-5) Loudness active Seek tuning sensitivity Alternative frequency for RDS operation A traffic station is being received Priority for traffic stations Manual station tuning CD track < Cassette loading slot Insert the tape with side A or 1 facing up, the open side showing to the right. > REL (Releasing the detachable face) The face of this unit can be detached for extra antitheft protection. You should take the detachable face with you when you leave your car. But RDS also offers you further advantages: If "SEARCH" appears in the display when you switch the radio on or when you recall one of the stored frequencies, the unit is automatically searching for an alternative frequency. "SEARCH" will disappear from the display when the alternative frequency has been found or after the frequency band has been run through completely. If the sound quality of the selected programme deteriorates appreciably: · Tune into another station. DEUTSCH ENGLISH PORTUGUÊS ESPAÑOL NEDERLANDS FRANÇAIS Selecting a waveband (only Cleveland DJ A) You can select between the following wavebands: FM 87. 5 - 108 MHz M 531 - 1602 kHz L 153 - 279 kHz · Press the BND button until the desired waveband shows on the display panel. AF - Alternative frequency The AF (Alternative Frequency) function makes sure that the strongest frequency of the currently selected programme is always tuned in automatically. This function is activated if "AF" appears in the display. In order to switch this function on or off, · press the AF button for about 1 second. While searching for the strongest reception signal, the radio may switch to mute briefly. 69 Station tuning Automatic tuning · / Press / ; the car radio will automatically search for the next station, if "m" does not light up in the display. If you hold down the upper or lower part / of the rocker switch, seek tuning will speed up in the upwards or downwards direction. To tune to a station manually: · Press / - the frequency will change in short intervals in the downwards or upwards direction. If you hold down / , the frequency scan will speed up. Changing the memory bank You can shift between the memory banks I, II and T in order to store stations and recall them later. The selected memory bank is indicated in the display. · Press the BND button as many times as necessary until the desired memory bank lights up in the display. With the Cleveland DJ A you can also use BND to switch over to medium-wave (M) or long-wave (L). Selecting the seek tuning sensitivity You can alter the automatic seek tuning sensitivity. [. . . ] The cassette will be ejected. Reversing the tape Press both buttons at a time. "TR 1" or "TR 2" will appear in the display. Fast winding Fast forward · Press FF (fast forward). When the end of the tape is reached, the mechanism will reverse the tape and start playing the other side. To change the tape direction during cassette playback: · Press FR and FF briefly. At the end of a tape side the mechanism changes directions automatically to play the other side (autoreverse). [. . . ]