User manual BLAUPUNKT DALLAS RMD169

[. . . ] Radio / MD Dallas RMD 169 US Operating instructions 1 2 3 4 5 13 12 11 10 9 8 7 6 19 14 15 2 18 1 3 21 20 17 16 2 KeyCard anti-theft protection system . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13 Switching on the unit . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13 Removing the KeyCard . . . . . . . . . . . . . . . . . . . . . . . . 13 Teaching in a second KeyCard/ replacing a KeyCard . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Stations can also be stored manually on the Travelstore level if required (see "Storing stations"). AM, AMT You can call up the stations on the selected frequency band directly: · Press the keys ST1 - ST6. Calling up stations on the other frequency band: · Press NEXT: the other frequency band is displayed. Then select the stored stations using ST1 -ST6. 18 Sampling stations with Radio Scan You can sample briefly the stations which can be received on the selected frequency band. Radio Scan can be started only when PTY is deactivated ("PTY" is not lit on the display). If necessary, deactivate PTY on menu level 2. Proceed as follows: Press TU and disable PTY using the PTY key. Switching on Scan: · Press SCA briefly. All stations on the frequency band which can be received are sampled briefly in turn. "SCAN" and the flashing station name/frequency appear alternately on the display. Selecting a sampled station/deactivating Scan: · Press SCA or one of the rocker keys briefly. If a station is not selected, Scan is switched off automatically when the seek function has passed through the complete frequency range. The station previously selected is played. · Changing the sampling time (Scan) The sampling time can be selected between 5 and 30 seconds. If you wish to change the duration of the sampling time, refer to "Programming with DSC ­ SCANTIME". Toggling between stereo and mono (FM) You can toggle between stereo and mono in the DSC menu. This can be useful in areas where reception is critical. When the unit is switched on, stereo is selected automatically. When reception is poor, the unit switches smoothly to mono. If you wish to switch to mono, refer to "Programming with DSC ­ STEREO/ MONO". The state selected appears briefly on the display. Changing the sensitivity of the seek run You can change the sensitivity of the automatic seek run. If "lo" is displayed, seek only recognizes stations with good reception (low sensitivity). If "lo" is not displayed, seek also recognizes stations with poorer reception. To adjust the sensitivity, refer to "Programming with DSC ­ FM/AM Sens". Automatic bandwidth switching (SHARX) You can activate automatic bandwidth switching on the FM band by means of the SHARX function in the DSC menu. [. . . ] ­ To avoid causing damage to your radio, use the corresponding Blaupunkt adapter cable to connect the 8-pin +/- ISO plug in the vehicle. While installing and connecting this equipment, please observe the following safety notes. ­ Disconnect the negative battery terminal. ­ Observe the car manufacturer's safety instructions. [. . . ]