User manual BLAUPUNKT DENVER CD147

[. . . ] FCC Warning The equipment has been tested and found to comply with the limits for a Class B device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and, if not installed and used in accordance with instructions, may cause harmful interference with radio communications. However, there is no guarantee that radio interference will not occur in particular installation. [. . . ] DIS (Display)/MENU Button Display Change Menu Access Demo Message Off/On (8 second press) 10. /\ Seek Tuning Up Menu Feature Select Bass, Treble Increase Fade to Front Name Character Select 11. V Button Seek Tuning Down Menu Feature Select Bass, Treble Decrease Fade to Rear Name Character Select 12. << Manual Tuning Down Menu Feature Adjust Track Down Audible Review 13. 14. 21. Bass, Treble Decrease Balance Left Name Character Position >> Manual Tuning Up Menu Feature Adjust Track Up Audible Cue Bass, Treble Increase Balance to Right Name Character Position Display RPT (Repeat) Track Repeat BND (Radio Band)/Travel Store Button FM/AM Band Acces FM/AM Travel Store MIX Button SCA (Scan) Button Station Scan Preset Scan Track Scan Pause Button LD (Loud)/SENS Button Loudness On/Off Tuning Sensitivity Select FM/AM Preset Buttons 12 Instructions -- General Operation See Traffic Safety & Precautions on page 4. "Press" means a momentary press of less than 1/2 second. All presses requiring more than 1/2 second are followed by beep. (Beep for all button presses available through Direct Software Control Menu. ) "Time Out" When additional button presses are anticipated to complete a procedure, the unit will automatically exit the procedure after 4 seconds of inactivity. (8 for Menu mode. ) Ignition-Off Clock Recall Any button press while ignition off displays time for 8 seconds. Ignition-On Unit lights up and clock is displayed. Demo Mode The unit is programmed to scroll some key features across the display if no button is pressed for one minute . (You may have seen this at the store where you purchased your radio. ) TO TURN THIS OFF, turn the unit on and press DIS for 8 seconds until "DEMO OFF" appears. (Pressing DIS for 8 seconds again will re-activate this feature. ) Release for Detachable Faceplate Push REL to detach face. Current settings and source mode are stored, except when detach occurs during Menu mode, new Menu settings are not stored. If power was not switched off before face removed, unit will automatically power-on when face is reattached. Power (PWR) On/Off When ignition on, press PWR or insert a disc to turn unit on. Last-used source becomes active, unless unit is turned on by inserting disc, in which case CD player becomes active. Turn-On Message (To turn message off or modify message, see Menu, page 19. ) 2. "RADIO", "CD PLAY" or "AUX IN". Functional information sequence (See Display Options, below. ) 4. Display Options Press DIS to change information shown at times when no manual or automatic activity takes place. Choice of priority display is separate for each audio source: Radio: Station Name (if named) --> Frequency --> Clock CD: Track No. /Elapsed Play Time --> Clock AUX: "AUX IN" - Clock After a change in source, radio station or CD play, the current source's non-clock displays are shown in sequence, then display returns to current source's priority display. Source (SRC) Use SRC to select source - radio or CD (if already inserted) and/or auxiliary input (even if no input on aux in line) as per model's features. [. . . ] "NAME" and "DELETED" blink alternately. Wireless Remote Control For added convenience you can control key features of your Blaupunkt 5 Series Receiver with either of two Blaupunkt wireless remote controls, the RC-06H or the ThummerTM. The unique Thummer mounts to the inside of the steering wheel rim and allows you to control the receiver without taking your hand off the steering wheel. The RC-06H is a credit card-sized remote control. To receive wireless commands, your receiver is equipped with a built-in infrared sensor (or "eye") on the faceplate. [. . . ]