User manual BLAUPUNKT DUSSELDORF CM 102

[. . . ] Operation Instructions Düsseldorf CM 102 2 3 4 5 6 7 8 9 10 11 12 13 14 1 22 21 20 19 18 17 16 15 KEY C ARD Display Radio 18 Display Cassette 18 Display CD-Changer 18 a b c de f g h j m i kl 3 Front Panel Description 1 ON/OFF Switch on the set by turning the knob. Volume control: by turning the knob SCAN (search operation): Pressing the button briefly samples the stations during radio reception or the next song during tape or CD operation (only CD changer). 2 GEO button (broader interior sound impression) Balance (left/right volume): Adjust with rocker switch <</>> D. Fader (front/rear volume): Adjust with rocker switch / E. [. . . ] Selecting MW or LW q Briefly press the M·L button ?. `M' for MW or `L' for LW lights up on the display B b. For changing between MW and LW: q Press M·L ?For jumping from one stored station to another: q Press the FM·T button A. For memorizing a station: q Choose the storage level (only FM); for this, press FM·T A until I, II, III, or T is lit on the display B c. q Tune in the station (see chapter Automatic/Manual Tuning of Stations) q Press the desired preset button > until the broadcast becomes audible again (approx. From the display B d you can see which button is currently pressed. Now the station is stored. Note: When tuning in an already stored station, the display B d will show the corresponding preset button for approx. In addition, for FM, the display B c will also give you the storage level. Activating a Stored Station If required, the memorized stations can be activated at a keystroke. For this, press FM·T A until I, II, III, or T lights up on the display B c. q Briefly press the corresponding preset button >. Automatically Storing the Strongest Stations (Travelstore) With Travelstore, you have the opportunity to automatically store the six strongest FM stations of your respective region and have them sorted according to their signal strength. This feature is of special use while travelling. q Press the FM·T button A for at least two seconds. The set searches for the strongest FM stations and sorts them on the `T' storage level (Travelstore). Once the process is finished, the car radio automatically tunes in to the strongest station. If required, it is also possible to manually store a station on the Travelstore level. If less than six stations can be received, the free buttons are represented by dashes for a short period of time. Briefly Sampling a Station (Radio Scan) Starting with the currently tuned in station, you can have the following ones briefly sampled for approx. If the following station is found, it is reproduced for approximately eight seconds. The station's frequency starts blinking on the display B a; if it has already been memorized, the corresponding preset button starts blinking on the display B d. In addition, for FM stations, the storage level indicator lights up on the display B c. Subsequently, the set starts searching for the next station. For selecting a sampled station: q Press the Scan button 1 once again. [. . . ] For changing it and entering the desired character: q Press the rocker switch << / >> D on the right continuously. Loudness Since your in-car sound quality is influenced by the type of the installation (amplifier), the type and arrangement of the loudspeakers, and the vehicle itself, you may individually programme at which level you want the set to start boosting the basses (loudness). For changing this loudness level, q press the DSC button 5. The car radio's volume is identical to the volume of the traffic messages. q Now press the rocker switch / E until `Loud' and a number between 1 and 6 illuminate on the display B a. [. . . ]