User manual BLAUPUNKT DSSELDORF RCR 84

[. . . ] Instructions for installation and connection Disconnect the battery ground wire during installation and connection. When drilling a hole, be sure not to damage any vehicle part (battery, cable, fuse, etc. [. . . ] Some Mercedes vehicles are equipped with a 10-pin connector located in the installation compartment. This connector must not be hooked up to car radio, since otherwise the positive supply line feeding the antenna or amplifier would be shortcircuited to ground! as a result , one of the conductive tracks in the radio would start burning. Note: By means of the support included in the delivery you can mount the set in cars with a DIN car radio cut-outout of 182 x 53 mm, an installation depth of 165 mm and an instrument panel thickness around the fixing clips of 1 - 20 mm, see fig. For cars with other cut-out dimensions Blaupunkt delivers car-specific installation kits for common car types for 50/52 mm sets. Please check the dimensions and, if necessary, use a car-specific installation kit, e. When using installation sets for units of 52 mm four distance plates, order number 8 601 055 056, must be used, fig. Connect the permanent plus terminal together with the cable and cable clamp to a fuse-protected positive line (e. Install the car radio into the DIN cut-out provided in your car's dashboard ex factory. Prepare the car radio DIN cut-out (unlock shelf or dummy cover) or cut out the car radio compartment to 182 x 53 mm. [. . . ] Stick in byglar till vänster och till höger i de befintliga hålen i panelen och tryck in så långt, att ett tydligt knäpp hörs (sidofjädrarna går ur ingrepp). En pluskabel (röd) med grov area (2, 5 mm2) dras direkt till batteriet. [. . . ]