User manual BLAUPUNKT FLENSBURG CC

[. . . ] 12 Storing the strongest stations automatically . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12 Recalling stored stations . . . . . . . . . . . . . . . . . . . . . . . 12 Appendix . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14 FRANÇAIS Technical data . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] 4 Display for frequency range frequency memory bank ARI priority ARI station code channel preset stereo manual fine tuning sensitivity (station search) 5 Station selection automatic or manual ("m" in display). Switch over by pressing lo · m 6 6 lo · m Changing the search tuning sensitivity for FM stations Io lit up in the display indicates normal sensitivity for the station search function. Io not lit up in the display indicates high sensitivity for the station search function. m lit up indicates manual station fine tuning. Added feature: Switch over from stereo to mono: Press lo · m for longer than 2 seconds. 7 ARI (traffic messages) When ARI is visible in the display, you are able to tune into only those radio stations which broadcast traffic messages. 8 1- 5 For storing and recalling radio stations 9 FM·T (frequency modulation) Switch for the FM memory banks I, II, III and "T" (Travelstore) - for storing and recalling the six nearest, strongest station signals. Store "T": Press FM·T until the search begins in the display. Recall "T": Press FM·T until T appears in the display. Then press the station button quickly and repeatedly if necessary. more bass more treble 10 Manual station search m (manual) must be lit up in the display. Stations using the ARI system broadcast an "ARI signal" during their programmes, so that your car radio can recognize them. Another signal is broadcast to indicate the beginning and end of a traffic message. These traffic messages are broadcast at a preset volume. If you are playing a cassette, it will be interrupted until the traffic message has ended and will then resume operation. Switching the traffic messages (ARI) on and off If you want to switch the reception of traffic messages (ARI) on or off · Press ARI. ARI will light up in the display, when the reception is switched on. Now the radio will only pick up those stations broadcasting the ARI signal. Warning beep Should you leave the reception area of the station you are tuned to, then you will hear a warning beep after approximately 30 seconds. If you should press a button preset for a station which does not broadcast the ARI signal, then you will also hear a warning beep. store up to five stations using the button 1-5. · Select the memory bank by pressing FM·T. · · Select the button 1-5 to store the new station and press it. [. . . ] · Select the station by pressing the button 1-5, press repeatedly if necessary. 12 Switching the warning beep off a) Tune to a different station broadcasting the ARI signal: · · Press or select a stored station with the ARI signal by pressing the button preset 1-5. Insert cassette tape · · Switch the car radio on. Insert a cassette tape with the empty reel facing forward and the open side facing to the left. When the tape has run to the end, the car radio will switch on automatically. Care of your audio equipment We recommend that you use only C60/C90 cassette tapes in your car radio. Protect your cassettes from dirt, dust and temperatures exceeding 50 °C. [. . . ]