User manual BLAUPUNKT GTB 200 A

[. . . ] The warranty terms can be called up from www. Please observe the following safety notes during the installation and connection. ­ When you drill holes, ensure that you do not damage any vehicle components. ­ If the positive and negative cable are extended, ensure that the cross section is not less than 2. [. . . ] The phase switch must be set so that the bass is integrated into the acoustic pattern as best as possible and not recognisable as an individual source. Also check your settings of the GTb 200 A with the bass control fully open and, if necessary, with activated loudness. One of the special features of the GTb 200 A is its automatic switch-on. The subwoofer box automatically switches on if a music signal is received. If there is no music signal for more than 60 seconds, the GTb 200 A automatically switches off. Please use the return and collection systems available to dispose of the product. Anslutning 6 kopplas till plus batteri och anslutning 7 kopplas till minus jord. 8/9 till de högtalarkablar (framtill eller baktill) som ligger närmast till vänster och höger. The amplifier power cable must be fitted with a fuse no more than 30 cm from the battery to protect the vehicle battery in case of a short circuit between power amplifier and battery. The fuse of the amplifier protects only the amplifier, not the vehicle battery. One of the special features of the GTb 200 A is its automatic switch-on. The subwoofer box automatically switches on if a music signal is received. If there is no music signal for more than 60 seconds, the GTb 200 A automatically switches off. The control of the GTb 200 A should ideally be a two-channel control, either via the preamplifier outputs or the loudspeaker outputs of the car sound system. A control solely via the right or left channel is also possible since the low-frequency portion of the music is generally identical on both channels. The preamplifier outputs are connected to the cinch (RCA) sockets of the subwoofer box via a shielded sound cable. with control via the loudspeaker outputs , the input connections of pos. 8/9 are fed to the closest loudspeaker cables (front or rear) on the left and right. Bridge output stages (BTL) can also be connected directly without an additional adapter. TIM function: For car sound systems with activated TIM function, the GTb 200 A must be controlled via the loudspeaker outputs of the car sound system and not via the RCA inputs (see page 29 / Fig. [. . . ] The following control setting is recommended as basic setting before putting the device into operation: Sensitivity (gain) Pos. Now slowly increase the gain control 1 until you can hear a clear amplification of the bass level. Next, use the crossover control 3 to select a filter setting that provides a well-contoured bass. you may have to alternately optimise the gain control setting 1 and the filter setting 3. [. . . ]