User manual BLAUPUNKT GTS POWER 6902 A

[. . . ] For devices purchased outside the European Union, the warranty terms issued by our respective responsible domestic agency are valid. The warranty terms can be called up from www. You can select between 3 different audio inputs; ­ Cinch (RCA) ­ Hi level (loudspeaker connections) ­ RF Link (wireless transmission) Use only one of the audio inputs; otherwise, it may lead to audio interferences. The preamplifier outputs are connected to the cinch (RCA) sockets 5 of the subwoofer box via a shielded sound cable. [. . . ] Next, use the crossover control 3 to select a filter setting that provides a well-contoured bass. you may have to alternately optimise the gain control setting 1 and the filter setting 3. A droning bass with excessive volume requires a filter setting with a low frequency. The phase switch must be set so that the bass is integrated into the acoustic pattern as best as possible and not recognisable as an individual source. Also check your settings of the GTs 6902 A with the bass control fully open and, if necessary, with activated loudness. Please use the return and collection systems available to dispose of the product. Anslutning 6 kopplas till plus batteri och anslutning 7 kopplas till minus jord. 8/9 till de högtalarkablar (framtill eller baktill) som ligger närmast till vänster och höger. If there is no music signal for more than 60 seconds, the GTs 6902 A automatically switches off. The control of the GTs 6902 A should ideally be a twochannel control, either via the preamplifier outputs or the loudspeaker outputs of the car sound system. A control solely via the right or left channel is also possible since the low-frequency portion of the music is generally identical on both channels. Please read these operating instructions before using the equipment for the first time. You can select between 3 different audio inputs; ­ Cinch (RCA) ­ Hi level (loudspeaker connections) ­ RF Link (wireless transmission) Use only one of the audio inputs; otherwise, it may lead to audio interferences. The preamplifier outputs are connected to the cinch (RCA) sockets 5 of the subwoofer box via a shielded sound cable. with control via the loudspeaker outputs , the input connections of pos. 8/9 are fed to the closest loudspeaker cables (front or rear) on the left and right. Bridge output stages (BTL) can also be connected directly without an additional adapter. for wireless transmission of the audio signal , connect the receiver to the RF Link socket <. TIM function: For car sound systems with activated TIM function, the GTs 6902 A must be controlled via the loudspeaker outputs of the car sound system and not via the RCA inputs (see page 32 / Fig. Please observe the following safety notes during the installation and connection. [. . . ] The subwoofer box automatically switches on if a music signal is received. The following control setting is recommended as basic setting before putting the device into operation: Sensitivity (gain) Pos. Now slowly increase the gain control 1 until you can hear a clear amplification of the bass level. Next, use the crossover control 3 to select a filter setting that provides a well-contoured bass. [. . . ]