User manual BLAUPUNKT HOLLYWOOD C30

[. . . ] Radio / Cassette Hollywood C30 Melbourne C30 Operating instructions Open here Ouvrir s. v. p. Por favor, abrir Favor abrir 2 1 2 4 3 5 6 17 7 8 16 9 15 14 13 10 11 12 3 SVENSKA NEDERLANDS ITALIANO FRANÇAIS ENGLISH ENGLISH PORTUGUÊS ESPAÑOL CONTROLS 1 2 3 4 5 6 7 8 9 : ; < = button to unlock release panel FM button, selects the FM memory bank Volume control knob ON button, switches the unit on/ off TS button, starts the TravelStore function AM button, selects the AM waveband Tape eject button Tape slot FR button, fast rewind FF button, fast forward GEO button, adjusts balance and fader CD·C button, switches sound source between tape, radio and CD changer (if connected) AUDIO button, adjusts bass and treble LD button, switches the loudness function on/off Cursor block MENU button, accesses the menus for making basic settings 1 to 5 station buttons button, indicates the time in the display > ?@ A 4 CONTENTS Traffic safety . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] The last settings used (radio, tape or CD changer) will be activated. q Switching the car audio system on/ off by pressing 4. To make it easier to select the desired volume, you will be able to hear any changes made while you are adjusting the volume. If you adjust this setting to 0, the car audio system will switch on at the volume used before it was switched off. Warning of serious injury When the power-on volume is set to the maximum level, it may be extremely loud when the car audio system is switched on. When the power-on volume is set to 0 and the car audio system was played at maximum volume before it was switched off, it may be extremely loud when the car audio system is switched back on. This could result in serious injury to your ears. Press 4 to switch the car audio system on. Press 4 for longer than 2 seconds to switch the car audio system off again. 8 VOLUME CONTROL Once you have selected the desired settings, press MENU ?. RADIO OPERATION Switching to the radio mode If you are currently using the tape player or CD changer, ENGLISH PORTUGUÊS ESPAÑOL SVENSKA NEDERLANDS ITALIANO FRANÇAIS ENGLISH Radio operation Mute You can reduce the volume of the car audio system immediately (mute). Press 4. Selecting the mute level It is possible to select the mute level. press CD·C < repeatedly until "RADIO" appears in the display. Selecting wavebands/memory banks Using this car audio system, you can tune into radio stations on the FM and AM wavebands. There are three memory banks for the FM waveband and one memory bank for AM. You can store five stations in each of these memory banks. Press > repeatedly until "MUTE LEVEL" appears in the display. Press level. > to select the mute Once you have made your selection, press MENU ?. To switch between the FM wavebands FM1, FM2 and FMT, press FM 2. Selecting AM Telephone mute If your car audio system has been equipped with a mobile telephone, it will automatically switch to mute when you use the phone. This will not work unless the mobile phone is connected to the car audio system as described in the installation instructions. The car audio system will be muted to the mute level selected. To switch between the AM waveband, press AM 6. Tuning into radio stations You can tune into radio stations in a number of different ways. The radio will tune into the next available station within reception range. Press 9 RADIO OPERATION Adjusting seek tuning sensitivity It is also possible to adjust the sensitivity of the seek tuning function. In this way you can adjust the radio to tune into stations with strong reception signals only, or to those with weaker reception signals as well. Press and hold down one of the station preset buttons 1 to 5 @ on which you want to store the radio station for longer than one second. Storing radio stations automatically (TravelStore) You can automatically store the five radio stations with the strongest reception in the area. These stations will be stored in the FMT or AM memory bank, depending on which waveband you have selected. Note: Any stations stored previously in the memory bank will be deleted. Press MENU ?. Press > repeatedly until "SENS" appears in the display. Press >. The currently selected setting will appear in the display. "SENS HI" indicates the highest level of sensitivity, "SENS LO" the lowest. If you select "SENS LO", "lo" will light up in the display. > to adjust the desired sensitivity. Press TS 5 briefly. The storing process will begin. "TSTORE" will appear in the display. After the stations have been stored, the radio will automatically begin to play the station stored on preset button 1 for the corresponding memory bank. Press Once you have made your selection, press MENU ?. [. . . ] Respecter les consignes de sécurité du constructeur automobile !- Veiller à n'endommager aucune pièce du véhicule en perçant des trous. 60 Durante el montaje y la conexión es imprescindible observar las siguientes normas de seguridad. - Desemborne el polo negativo de la batería. [. . . ]