User manual BLAUPUNKT IVMS 5802

[. . . ] 17 Accessories supplied . . . . . . . . . . . . . . . . . . . . 17 Available accessories . . . . . . . . . . . . . . . . . . . . 17 Specifications . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] You can view the guarantee conditions at www. blaupunkt. de or ask for them directly at: Blaupunkt GmbH Hotline Robert Bosch Str. 200 D-31139 Hildesheim To avoid the risk of electrical shock, the device must be protected from water and moisture, and must not be opened. Dangerously high voltages are generated inside the device. We wish to point out that the right to claim against warranty is invalidated by any changes or modifications to the device that have not been explicitly approved by the manufacturer. Long-term operation or storage outside the specific temperature range can lead to a shortening of the useful life of the LC display. Safety notices Please observe the following safety notices during installation and whilst making the connections. - Disconnect the negative and positive terminals of the battery. - When doing so, please observe the safety notices provided by the vehicle manufacturer. - Before drilling the holes necessary for mounting the equipment and for laying cables, please make sure that concealed cables, the fuel tank and fuel lines cannot be damaged in the process! Important notes This device is not intended for fitting in the forward section of the passenger compartment where it could also be seen by the driver. Fitting this device in any part of the vehicle where it could interfere with or distract the driver's attention is dangerous and is not permitted. The manufacturer cannot accept responsibility for any damage caused as a result of improper fitting of this device. 16 ACCESSORIES Accessories Accessories supplied Connecting cable Extraction tool Operating instructions Mounting plate Adapter cable for a direct connection to an AV source - IR remote control IVRC-06 FITTING Monitor installation Note: It is recommended that the fitting is carried out at a specialist workshop. DEUTSCH DANSK PORTUGUÊS ESPAÑOL SVENSKA NEDERLANDS ITALIANO FRANÇAIS ENGLISH Fitting Prepare the working area Remove the headrest, and place it on a working surface that has been cleared and cleaned, where the further assembly procedures may be carried out. Note: Take appropriate action to ensure that the headrest is not damaged while fitting the monitor. Available accessories - Monitor bracket 7608009300 The installation instructions are included with the bracket. Note regarding VIDEO IN/AUX: Only use original Blaupunkt accessory 7 607 001 510. Or else use a mono plug. Mark out the dimensions Feel the covering of the headrest carefully to ensure that there are no invisible parts that would prevent the monitor from being fitted. Mark out the surface that needs to be cut out - its size must match that of the installation frame. 17 FITTING Open the headrest and remove filling and other items Carefully lift the covering material away from the cut area. Adjust the cutting depth of the knife to about 2. 5 cm, and cut into the headrest following a line about 0. 5 cm inside the marked edge. Carefully lift the filling material at one corner, and cut deeper into the material with the knife. [. . . ] Press the "EXIT" option to close the OSD menu again. TINT: To adjust the picture shade (only for NTSC) REVOLVE: To revolve the screen display - LEFT - RIGHT Horizontally mirrored - UP - DOWN Vertically mirrored RESET PICTURE: To reset the configured parameters to the factory default settings. EXIT: To close the OSD menu ZOOM BRIGHTNESS CONTRAST COLOR TINT REVOLVE LEFT-RIGHT UP-DOWN RESET PICTURE EXIT ZOOM (picture size): Change the picture height/width - FULL - NORMAL - WIDE BRIGHTNESS To adjust the brightness CONTRAST: To adjust the contrast COLOR: To adjust the colour 22 IR REMOTE CONTROL Functions The supplied remote control is suitable for operating the following monitors: IVMS-5802 and IVMS-6502. 3 VOL · arrow button Increase the volume for the selected monitor. [. . . ]