User manual BLAUPUNKT IVSC-5502

[. . . ] 13 Functions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13 Settings for Audio OUT . . . . . . . . . . . . . . . . . 14 Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] When installing the signal controller, select a location in the vehicle that allows you to attach it firmly into place using screws. The installation location should be such that the signal controller does not get in the way of the driver and cannot endanger the occupants in the event of the vehicle suddenly coming to a halt, for instance, during an emergency stop. The IR remote control should not be installed within the inflation range of airbags (driver, passenger side, side airbags) or in any position where it could be struck by the vehicle occupants' heads or knees. With regard to the installation location and the attachment using an adhesive pad, check and ensure that the holding strength of the installation surface is sufficient and suitable for all situations and safety requirements. Accessories We recommend you use accessories that have been approved by Blaupunkt. 11 SUPPLIED PARTS Supplied parts The signal controller is supplied with all the parts listed below. Please check that the range of parts supplied with your device is complete. If one of the listed parts is missing, please contact your dealer immediately. SWITCHING ON/OFF Switching on/off Switching on the signal controller The signal controller is switched on via the "+12V ignition" switching line by the connected control device. Signal controller 7 607 003 551 Switching off the signal controller The signal controller is switched off via the "+12V ignition" switching line by the connected control device. Switching on/ off. Connecting cable Screws IR remote control IR receiver Operating and installation instructions 12 SETTINGS Settings External monitor switch (Fig. 2) Switch position on right: No external monitor connected. Switch position on left: If a Blaupunkt navigation (RGB) monitor is connected via a Y-cable (7 607 001 600). IR REMOTE CONTROL Functions The supplied remote control is suitable for operating the signal controller and the monitors. You must enter a button combination in order to control a single monitor or all the monitors simultaneously. To do so, you first select the monitor (FRONT/LEFT/RIGHT-OVERHEAD or ALL) and then the function that you require. The selected monitor or monitors remain(s) selected until you press one of the buttons (FRONT/ LEFT/RIGHT-OVERHEAD or ALL) again. 1 POWER NAVI MUTE Note: From the FRONT, LEFT, RIGHT and OVERHEAD monitor output, you can optionally assign the 8 or 13 PIN jack. 4 < ; : 9 8 BOOSTER AUDIO CH VOL CH 5 FRONT LEFT ALL RIGHT OVERHEAD IVRC 05 13 DANSK 7 PORTUGUÊS ESPAÑOL SVENSKA NEDERLANDS ITALIANO FRANÇAIS Monitor connections ENGLISH DEUTSCH IR remote control IR REMOTE CONTROL 1 POWER On/off button for the selected monitor or monitors. 3 VOL · arrow button Increase the volume for the selected monitor (not Audio OUT). VOL · arrow button Decrease the volume for the selected monitor (not Audio OUT). 4 MUTE Mute the volume for all the connected monitors and Audio OUT. 5 CH · arrow button / Select the input source for the selected monitor. [. . . ] Scratch the surface down to the bare metal at the point at which the ground is made. · If the installation requires holes to be drilled or any other changes to be 15 INSTALLATION made to the vehicle, please contact a specialist workshop in your area. Note: You cannot display PAL video on the wide vision TV monitor using the RGB input. [. . . ]