User manual BLAUPUNKT JACKSON CM148

[. . . ] Cassette ~~tQpedi~ i t!P Control cassette et c~~t~~le de chanlelrr 6 Receptor cun Cassette y Control Camhiador Radii-C~ssete corn CantrQ"le par t~~hi~d~r C Bosch Group FCC Warning The equipment has been tested and found to comply with the limits for a Class B device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and, if not installed and used in accordance with instructions, may cause harmful interference with radio communications. However, there is no guarantee that radio interference will not occur in particular installation. [. . . ] Never use a fuse that has a stated amperage exceeding the one supplied for this unit, as this could cause malfunction and serious damage to the unit. 10 Wecifications Audio Power Specifications . Power Output and Total Harmonic Distortion: 13. 5 watts per channel minimum continuous average output into 4 ohms, 4 channels driven, from 30-15, 000 Hz with no more than 1% total harmonic distortion. Other Specifications Tuner FM Tuning Range: Intermediate Frequency: FM Mono Sensitivity: Seek lo sensitivity: Seek sensitivity Selectivity: Signal-to-Noise Ratio: Harmonic distortion at 1 kHz: Separation: Frequency Response: AM Tuning Range: Seek lo sensitivity Seek sensitivity: Intermediate Frequency: Signal-to-Noise Ratio: Frequency Response: 87. 5 - 107. 9 MHz 10. 7 MHz 13 dBf 51 dBf 31 dBf 80 dB at 4OOkHz 65 dB (stereo), 70 dB (mono) 0. 7% (stereo), 0. 5% (mono) 30 dB 30-l 5, 000 Hz k 3 dB 530 - 1, 710 kHz 50 dBpV 25 dBpV 450 kHz 50 dB 30-5000 Hz + 3dB 4-8 ohms 4 X 35 Watts (at 4 ohms) 4 X 13. 5 Watts (at 4 ohms) ~1% THD +lOdB @I 100Hz f10dB @ 10kHz +8dBQ60Hz&+2dB@8kHz 4-Channel, Low-lmpendance (100 Q) Preamplifier Over 3 Volts of Distortion-Free Preamp Output 55 dB 65 dB 0. 10% dB 30-l 8, 000 Hz + 3 dB 180 x 52 x 155 mm, 7 x 3 x G'/ein. 1. 4 kg (3. 0 lb. ) 12 V DC car battery (1 l-l 6 V DC allowable) 15°F to 12O"F, -10°C to 50°C Unit Faceplate Wire Harness, including 2-Channel RCA Preamp Output Harness DIN Sleeve Mounting Hardware Owner's Manual in English, French, Spanish and Portuguese 4-Channel Preamp Output Harness (Part No. 8634494218) CDC-A05, CDCA071, CDC-A08 CD Changers, CDC-A08 adapter 7607898093 l l l l l l l l Audio Speaker Impedance: Maximum Amp Power: RMS Power: Bass Control: Treble Control: Loud: Preamp Output: Cassette Signal-to-Noise Ratio: with Dolby B Noise Reduction: Tape Wow and Flutter: Tape Frequency Response: General Dimensions (w/o projecting parts/controls): Mass: Power Requirement (neg. grnd. ): Operating Temperature: Supplied Accessories: Optional Accessories: Design and specifications subject to change without notice. 11 Location of Controls 12 3 4 5 6 78 9 10 11 f (/ CD CHhNGER ZONTRC LLER 3 fillnl0 TS SENS OISP 35 WAlTS x 4 l HIGH POWER 0 BLAUPUNKT \y --r Y-. -- JJI 22 12 13 14151617 18 19 20 21 1. LD (Loudness)/ SENS (Tuning Sensitivity) 8. + Button Volume + Bass + Treble + Balance Left Fade to Front 13. - Button Volume Bass Treble - Balance Right Fade to Rear 14. A Button Seek and Manual Tuning CD Track Up Audible CD Cue Clock Hours 15. V Button Seek and Manual Tuning CD Track Down Audible CD Review Clock Minutes 16. Display Instructions - General Operation See Traffic Safety & Precautions on page 4. "Press"means a momentary press of less than l/2 second. All presses requiring more than l/2 second are followed by beep. "Time Out" When additional button presses are anticipated to complete a procedure, the unit will automatically exit the procedure after 4 seconds of inactivity. 12 Ignition-Off Clock Recall Any button press while ignition off displays time for about 8 seconds. Ignition-On Unit lights up and clock is displayed. Release for Detachable Faceplate Push REL to detach face. Already-inserted cassette remains in unit. Current settings and source mode are stored. If power was not switched off before face removed, unit will automatically poweron when face is reattached. Power (PWR) On/Off When ignition on, press PWR or insert a disc to turn unit on. Last-used source becomes active, unless unit is turned on by inserting tape, in which case tape player becomes active. Unit stores current settings for source, station or track, etc. Antenna/ amplifier trigger wire shuts off voltage. [. . . ] Disc Scan Press and hold SCA for more than 2 seconds to start Disc Scan. Disc Numbers blink during scanning operation. Unit stops at first track on each disc for 10 seconds. Unit continuously scans until user stops scan by pressing SCA, another playback control or SRC. [. . . ]