User manual BLAUPUNKT LEXINGTON CM84

[. . . ] 6 Accessories . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 ENGLISH PORTUGUÊS ESPAÑOL FRANÇAIS Notes and accessories . . . . . . . . . . . . 7 Theft protection . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Detaching the control panel . . . . . . . . . . . . . [. . . ] If necessary, clean the contacts with a lint-free cloth and some alcohol. off the unit and then out towards the left. The unit switches off after the control panel is removed. All current settings of the radio are saved. CD already inserted in the unit remains there. Attaching the control panel Slide the control panel from left to right into the unit's guide. Press the left-hand edge of the control panel into the unit until it clicks into place. Detaching the control panel 1 Press the button 1. Note: When attaching the control panel, make sure you do not press on the display. If the unit was still switched on when you removed the control panel, the unit will automatically switch back on with the last settings activated i. e. radio, CD or CC changer (CD changer only with the Lexington C32) when the panel is reinserted. The control panel locking mechanism opens. 7 PORTUGUÊS ESPAÑOL FRANÇAIS ENGLISH Removable control panel First, pull the control panel straight SWITCHING ON/OFF Switching on/off There are various ways of switching the unit on/off: Switching on/off using the vehicle ignition If the unit is correctly connected to the vehicle's ignition and it was not switched off using button 2, it will switch on/off simultaneously with the ignition. Switching on/off using the removable control panel ADJUSTING THE VOLUME Adjusting the volume The system volume can be adjusted in steps from 0 (off) to 100 (maximum). To increase the system volume, turn the volume control 3 clockwise. To decrease the volume, turn the volume control 3 anticlockwise. Setting the power-on volume You can set the unit's default power-on volume. Remove the control panel. The unit switches off. Attach the control panel again. The unit switches on. radio, CC or CD changer (CD changer only with the Lexington C32) will be reactivated. Switching on/off using button 2 Press the MENU button 8. Note: Any stations that were previously stored on this memory bank are deleted in the process. Set the required sensitivity using the and buttons 8. When you have finished making your changes, press the MENU button 8. Tuning into stations manually You can also tune into stations manually. Press and hold the BAND/TS button = until seek tuning begins. Once the procedure finishes, all the stored stations are played briefly. Listening to station presets Select the memory bank on which the station was stored. Press the or button 8. Press the preset station button 1-6 < of the station you want to listen to. 10 CASSETTE MODE Cassette playback If there is no cassette inserted in the unit. Fast-forwarding To fast forward side A/1, Insert the cassette with its open edge on the right and side A/1 facing up into the cassette compartment 5. The side of the cassette that is facing up is then played first of all (side A/1). The cassette symbol appears in the display. If a cassette is already inserted in the unit. 7 so that it clicks into position. To fast forward side B/2, press the FR tape-winding button 6 so that it clicks into position. "TAPE FF" appears in the display. Fast-rewinding To fast rewind side A/1, Keep pressing the SOURCE button 9 until "TAPE" appears in the display. The cassette is played in the direction that was last set. 6 so that it clicks into position. [. . . ] ­ Observe the car manufacturer's safety instructions. ­ If you drill any holes, make sure that you do not damage any parts of the vehicle. ­ The diameter of the positive/ negative cable must not be less than 1. 5 mm2. Consignes de montage et de branchement ­ En cas d'erreur d'installation ou d'entretien, des perturbations peuvent survenir au niveau des systèmes électroniques du véhicule. ­ Pour ne pas détériorer votre autoradio, branchez le connecteur ISO +/- 8 pôles du véhicule uniquement via un câble adaptateur Blaupunkt correspondant. [. . . ]