User manual BLAUPUNKT LUCCA 3.5 ITALY

[. . . ] X-BASS button, to adjust the XBass function. 9 : ; < Short press: AUDIO button, to adjust the bass, treble, balance and fader settings. button, to display Long press: the time. Short press: TRAF button to switch traffic information standby on/off. Long press: RDS button, to switch the RDS feature on/off. [. . . ] radio, CD, CD changer/Compact Drive MP3 or AUX) when the panel is replaced. Attach the control panel again. The unit switches on. The settings (radio, CD, CD changer/Compact Drive MP3 or AUX) that were set before the unit was switched off will be reactivated. Switching on/off using button 2 To switch the unit on, press button 2. To switch the unit off, press button 2 for longer than two seconds. The unit switches off. 29 SWITCHING ON/OFF Switching on by inserting a CD If the unit is switched off and there is no CD inserted in the drive, ADJUSTING THE VOLUME Adjusting the volume The system volume can be adjusted in steps from 0 (off) to 66 (maximum). To increase the volume, Gently insert the CD with the printed side uppermost into the drive until you feel some resistance. The CD will be drawn automatically into the drive. You must not hinder or assist the drive as it draws in the CD. CD playback begins. turn the volume control 3 to the right. To decrease the volume, turn the volume control 3 to the left. Setting the power-on volume You can set the default volume at which the unit switches on. Press the MENU button 7. Keep pressing the or button 5 until "ON VOL" appears in the display. Set the power-on volume using the and buttons 5. To help you adjust the volume more easily, the volume will be increased / decreased as you make your changes. AF: If this RDS function is activated, the unit automatically tunes into the best receivable frequency for the station that is currently set. REG: At certain times, some radio stations divide their programme into regional programmes providing different regional content. You can use the REG function to prevent the car radio from switching to alternative frequencies that are transmitting different programme content. Selecting the waveband / memory bank This unit can receive programmes broadcast over the FM, MW and LW wavebands. Note: The MW and LW wavebands are not available on the Essen CD33. There are three memory banks for the FM range and one for each of the MW and LW wavebands. Six stations can be stored in each memory bank. Note: REG must be separately activated/ deactivated in the menu. 32 RADIO MODE Selecting the memory bank To switch between the FM memory banks and the MW and LW wavebands, keep pressing the BND·TS button < until the required waveband / memory bank is displayed. DEUTSCH DANSK PORTUGUÊS ESPAÑOL SVENSKA NEDERLANDS ITALIANO FRANÇAIS ENGLISH Tuning into stations manually You can also tune into stations manually. Note: You can only tune into stations manually if the RDS function is deactivated. Tuning into a station There are various ways of tuning into a station. Press one of the station buttons 1 6 : for longer than one second to store the station to that button. Storing stations automatically (Travelstore) You can automatically store the six stations with the strongest reception in the region (only for FM). The stations are stored in the FMT memory bank. Note: Stations that were previously stored in this memory bank are deleted in the process. Keep the BND·TS button < pressed for longer than two seconds. "T-STORE" appears in the display. [. . . ] When you have finished making your changes, Press the press the button 5. Briefly displaying the time when the unit is switched off To briefly display the time when the unit is off, The hours flash. Adjust the hours using the buttons 5. When you have finished making your changes, press the MENU button 7 twice. Selecting 12/24-hour clock mode Press the MENU button 7. "MENU" appears in the display. press the AUDIO ( ) button 9. The time is displayed for around 8 seconds. Keep pressing the or button 5 until "24 H MODE" or "12 H MODE" appears in the display. 42 SOUND AND VOLUME DISTRIBUTION SETTINGS To adjust the left/right volume distribution (balance), DEUTSCH DANSK PORTUGUÊS ESPAÑOL SVENSKA NEDERLANDS ITALIANO FRANÇAIS ENGLISH Sound and volume distribution settings You can adjust the sound settings for each source separately (radio, CD, CD changer/Compact Drive MP3 and AUX). Adjusting the balance settings press the AUDIO button 9. "BASS" appears in the display. Adjusting the bass settings To adjust the BASS, Keep pressing the press the AUDIO button 9. "BASS" appears in the display. [. . . ]