User manual BLAUPUNKT MALIBU CR67

[. . . ] FCC Warning The equipment has been tested and found to comply with the limits for a Class B device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and, if not installed and used in accordance with instructions, may cause harmful interference with radio communications. However, there is no guarantee that radio interference will not occur in particular installation. [. . . ] Connect the leads (wires) according to instructions and diagram below. ELECTRICAL CONNECTION INSTRUCTIONS 1. Disconnect the vehicle battery's negative terminal before making connections. Connect the speakers following the guidelines in the SPEAKER CONNECTION section below. Connect the blue (trigger output) lead to the antenna motor trigger switch input terminal. The total amperage required of the blue lead must not exceed 300 mA. DO NOT connect the blue lead to the antenna's power supply input. Connect the black (power ground) lead to a grounded metal part on the vehicle. We recommend grounding all audio system black ground leads (head unit, RF CD Changer, etc. ) to a common grounding point, preferably a non-painted surface under the instrument panel. Connect the yellow (constant power) input lead to a source of constant battery power, preferably a terminal to an appropriate slot in the fuse box. Connect the red (turn-on power) input lead only after the other leads are connected. Be sure to connect the red lead to a positive (+) 12 Volt power terminal that is energized only when the ignition key is set to the on position or accessory position. Cover the ends of any unused leads with electrical tape. This will prevent them from touching the vehicle or each other and causing a short-circuit and damage to the radio or vehicle. Once the connections have been successfully made, you can begin to mount the unit. SPEAKER CONNECTIONS · You can connect a speaker (regular, co-axial or tri-axial speakers or component speaker system, all hereafter referred to simply as "speaker") to each of the units' four pairs of speaker leads. Connecting the Speaker Leads To prevent short circuits or serious damage to the receiver and/or speakers: · Connect the speaker leads only as indicated in the wiring diagram. Disconnect the vehicle battery's negative terminal before making connections. · Only use speakers that have impedance ratings of 4 ohms or higher and have power-handling capabilities greater than the receiver's stated power level. · The unit's internal amplifier is designed to handle a 4-ohm load on each pair of speaker leads. · DON'T connect two speakers to a single pair of speaker leads ("in parallel") unless both speakers each have at least 8 ohms impedance. · DON'T connect the left and right speaker leads to each other or to the same speakers. · DON'T connect the front and rear speaker leads to each other or to the same speakers. · DON'T connect the negative speaker leads to each other. [. . . ] (Note: Make sure that the side of the cassette exposed is facing right and that all slack has been removed from the tape prior to insertion. ) · If ignition switch is already in "on" or accessory position, insertion of cassette will turn unit on. If unit already turned on, cassette insertion will override other audio source, such as radio. Cassette play will begin, and the display will indicate which tape program is in use, "1" or "2". · The tape will continue to play until ejected, SRC button pressed, or unit turned off. [. . . ]