User manual BLAUPUNKT MELBOURNE C34

[. . . ] This equipment has been tested and found to comply with the limits for a Class B device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and, if not installed and used in accordance with instructions, may cause harmful interference with radio communications. However, there is no guarantee that radio interference will not occur in particular installation. [. . . ] This will only work if the mobile phone is connected to the car audio system as described in the installation instructions. You can select an equalizer curve for 3 music types (Rock, Pop, Classic). You can erase the turn on/off message if so desired. Press the MENU for more than 2 seconds to enter the audio adjustment mode. Press the MENU , then press the or play the "MESG ON" on the display window. Press the SRC or PWR , then rotate the VOL dial to select the desired message you want to erase. Press the MENU , then press the or play the "MESG ON" on the display window. To complete entering the entire message 9 characters max. (See page 3 "Adjusting the Sound Characteristics") Press and hold the (USER 1) or (USER 2) for more than 2 seconds to store the equalizer curve, while displaying "BAS/TRE" in the display window. To erase /correct a message, press the MENU for more than 2 seconds to clear the character and re-enter. â· If you make no button input or dial operation in 30 seconds, the message edit mode will turn off automatically. When entering a name, pressing the following buttons affects the display of characters as follows. Press the MENU for more than 2 seconds to enter the audio adjustment mode. You can edit the turn on/off message and store it in memory. Following four messages can be edit with 9 characters each. Unit will scan preset memory for the each 6 stations from the MW/LW band or the 18 stations from the FM bands. The unit will stop at each receivable station for 10 seconds, before continuing to the next preset station. Press the again to stop Preset Scan Tuning and remain this on the selected frequency. After 4 seconds of completing Manual Tuning, the tuning control will revert to the Seek Tuning mode. You can store up to 6 stations on each band (18 for FM, 6 for MW and LW) in the order of your choice. To resume playback, press the opposite direction button halfway to release the locked button. Press and hold the desired preset memory button 6 for about 2 seconds until the frequency indicator flashes twice. [. . . ] â· All speaker common (-) wires must remain floating. Connect each pair of speaker leads only to a single speaker (or speaker system) that has an impedance of least 4 ohms, as well as adequate power-handling capability. â· Do not connect speaker leads to any inputs on external amplifiers. This will cause damage to the internal amplifier of this unit. [. . . ]