User manual BLAUPUNKT MINNESOTA DJ30

[. . . ] 26 Accessories . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 26 Guarantee . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 26 International telephone information . . 38 Selecting CDs . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] You will find the code number in the Radio Pass. Note: Do not leave the Radio Pass in your vehicle!Activating/deactivating the code Entering the code number Switch on the car audio system. "CODE" and then "0000" will appear in the display. Press station key 1 @ repeatedly until the first digit of your code number appears in the display. Press station key 2 @ repeatedly until the second digit of your code number appears in the display. Press station key 3 @ repeatedly until the third digit of your code number appears in the display. Press station key 4 @ repeatedly until the fourth digit of your code number appears in the display. To switch the code on/off, proceed as follows: Press 4 to switch the car audio system off. When the correct code number appears in the display, press >. Note: If you enter the code number incorrectly three times in succession, a waiting period of one hour will go into effect. "WAIT 1 H" will appear in the display. During this waiting period, the car audio system must remain switched on. Press and hold down station keys 1 and 4 @ at the same time. While holding down these keys, press 4 to switch the car audio system on. Continue to hold down the keys until "BLAU" - "PUNKT" appears in the display. Release the keys. The coding has now been activated. To deactivate the code, follow exactly the same steps. To ensure that unauthorized persons do not deactivate the code, you will be required to enter the code to finish the process. 28 THEFT PROTECTION Activating/deactivating the LED code To visibly indicate that the Augsburg C30 and the Minnesota DJ30 are equipped with theft protection, you can activate the code LED. The code LED will flash in key 4 when the car audio system is switched off. SWITCHING ON/OFF DEUTSCH PORTUGUÊS ESPAÑOL SVENSKA NEDERLANDS ITALIANO FRANÇAIS ENGLISH Switching the car audio system on/off The car audio system can be switched on/off in a number of ways. Switching the car audio system on/ off with the ignition If the car audio system has been connected to your vehicle ignition, it is possible to switch it on and off with the ignition. You can also switch the car audio system on when the ignition is switched off. Press MENU ?. "MENU" will appear in the display. Press or > repeatedly until "LED" appears in the display. "OFF" or "ON" will appear next to LED in the display. To do this, start the TravelStore function. To switch between the MW and LW memory levels, press M·L 6 (not available for the Augsburg C30 and the Minnesota DJ30). Adjusting seek tuning sensitivity It is possible to adjust the sensitivity of the seek tuning function to tune the radio into stations with strong reception signals only, or to those with weaker reception signals as well. Tuning into radio stations You can tune into radio stations in a number of different ways. The radio will tune into the next available station within reception range. Manual station selection You can also tune into radio stations manually. Note: You cannot use manual tuning unless the RDS function and the PTY function are deactivated. Paging through the broadcasting network (for FM only) If a radio broadcasting network has more than one station, you can page through the "station network". Press MENU ?. "MENU" will appear in the display. or > repeatedly until "SENS" appears in the display. The currently selected setting will appear next to "SENS". "SENS HI6" indicates the highest level of sensitivity, "SENS LO1" the lowest. If you select "SENS LO", lo will light up in the display. Press Press sensitivity. > to select the desired Once you have made your selection, press MENU ?. Storing radio stations Storing radio stations manually Select the desired memory bank FM1, FM2, FMT or either MW or LW (MW and LW are not available for the Augsburg C30 and the Minnesota DJ30). Press or > to tune into the next station in the network. Note: To take advantage of this function, you must have activated the RDS functions and deactivated the PTY function. It is only possible to tune into those stations which have been received once Tune the radio into the desired station. Press and hold down one of the station preset buttons 1 to 5 @ on which you want to store the radio station for longer than two seconds. 33 RADIO OPERATION Storing radio stations automatically (TravelStore) You can automatically store the five radio stations with the strongest reception in your current reception area (for FM only). [. . . ] 39 CLOCK CLOCK Displaying the clock briefly Press and hold down MENU ( ) ?until the time appears in the display. Once you have selected the mode, press MENU ?. Activating the clock for display when the car audio system is switched off When the car audio system is switched off, but the vehicle ignition is switched on, you can activate the clock display. Setting the time To set the time, press MENU ?. "MENU" will appear in the display. Press or > repeatedly until "CLOCKSET" appears in the display. >. Press MENU ?. "MENU" will appear in the display. Press Press The time will appear in the display. The minutes will flash and can be altered. or > repeatedly until "CLOCKOFF" or "CLOCK ON" appears in the display. Press Press utes. or > to alter the min- or > to switch the clock display on or off. [. . . ]