User manual BLAUPUNKT MODENA CD50 YELLOW

[. . . ] @ button - opens the flip/release panel Arrow-key block OK button - confirms menu entries and starts the scan function X-BASS button to adjust and switch X-BASS on/off AUDIO button (Audio) - adjusts bass and treble, balance and fader Key block 1 - 6 TRAF button, switches traffic information standby on/off CD·C button - selects between CD, CD changer (if connected) and AUX sources 5 6 7 8 26 TABLE OF CONTENTS Road safety . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 28 Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 28 Accessories . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 28 International telephone information . . . . [. . . ] This requires the mobile telephone or navigation system to be connected to the car radio as described in the installation instructions. Your Blaupunkt dealer can tell you which navigation systems can be used with your car radio. If a traffic announcement is received during a telephone call, or while the navigation system is speaking, the traffic announcement is not reproduced 31 Note: To protect your hearing, the poweron volume is limited to a value of "38". If the volume level was higher when the unit was switched off, the volume will be reset to "38" when the unit is switched on again. When you have finished making your changes, ; twice. press the MENU button 8 or OK VOLUME ADJUSTMENT until the call or the speech output has finished. If a call is received or if the navigation system begins speaking during a traffic announcement, the announcement is reproduced. The telephone call or speech output can be heard when the traffic announcement has finished. The volume at which navigation output or telephone calls start is adjusted as follows: Press the MENU button 8. Press the or button : until "TEL/NAVI VOL" appears in the display. Set the desired volume with the buttons :. When the setting process is complete, press the MENU button 8 or OK ; twice. Note: The set scanning time also applies to scanning in the CD and CD changer mode. Listening to preset stations Select the memory or frequency range. ton 1 - 6 > of the desired station. Scanning receivable stations (SCAN) You can briefly listen in to all receivable stations. The scanning time can be set in the menu at between 5 and 30 seconds. Starting SCAN Hold down the OK button ; for more than two seconds. "SCAN" appears briefly on the display, followed by the current station name or frequency, which flashes. Besides transmitting the station name, some FM stations also provide information on the type of programme they are broadcasting. This information can be received and displayed by your car radio. For example, the programme types can be: CULTURE TRAVEL JAZZ SPORT NEWS POP ROCK CLASSICS You can use the PTY function to select stations of a particular programme type. 35 PORTUGUÊS ESPAÑOL SVENSKA Hold down the preset station but- Programme type (PTY) NEDERLANDS ITALIANO buttons : to set the desired scanning time. FRANÇAIS Setting the scanning time Press the MENU button 8. Press the or button : repeat- ENGLISH RADIO MODE PTY-EON When the programme type has been selected and the search started, the car radio switches from the current station to a station featuring the selected programme type. Note: If no station with the selected programme type is located, a beep sounds and "NO PTY" appears briefly on the display. The unit tunes into the station last received once again. If the set station or another station in the broadcasting network transmits the selected programme type at a later time, the car radio automatically switches from the current station - or from CD or CD changer mode - to the station featuring the desired programme type. Switching PTY on/off Selecting programme type and starting a search Press the or button :. The current programme type appears on the display. If you would like to select a different programme type, you can change to another programme time within the time the programme is displayed by pressing the or button :. [. . . ] The hours now flash. button : to switch between ON and OFF. Press the MENU button 8 or OK ; once you have completed the setting. Set the hours using the tons :. or but- Press the MENU button 8 or OK ; twice, once you have completed the setting. Briefly viewing the time when the car radio is switched off In order to view the time when the car radio is switched off, Selecting the 12/24-hour clock mode Press the MENU button 8. "MENU" appears on the display. press the button / DIS 7. The time appears on the display for eight seconds. Press the or button : repeatedly until "24 H MODE" or "12 H MODE" appears on the display. 43 TONE AND VOLUME BALANCE Tone and volume balance You can adjust the tone and volume balance separately for every audio source (radio, CD, CD changer, AUX and traffic announcements). Note: Adjustments to tone and volume balance for traffic announcements can only be made during a traffic announcement. Setting the volume distribution left/right (balance) To set the volume distribution left/ right (balance), press the AUDIO = button. "BASS" appears on the display. Press the button : repeatedly until "BALANCE" appears on the display. or button : to set the volume distribution left/right. Adjusting the bass Press the AUDIO = button. "BASS" appears on the display. Press the Press the AUDIO = button once you have completed the setting. Press the the bass. or button : to set Press the AUDIO = button once you have completed the setting. Setting the volume distribution front/rear (fader) To set the volume distribution front/ rear (fader), press the AUDIO = button. [. . . ]