User manual BLAUPUNKT NAVIRECHNER RGS 08

[. . . ] TravelPilot RGS 08 5" TFT Display 8 622 401 425 (GB) 7 612 001 293 Installation notes for authorired service workshopsInstructions de montage pour atelier service après-vente agréé -1- Table of contents Safety information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Installation and connection regulations . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Product information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Notes on the operation of the equipment . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] The adherent surface of the antenna must be free of dirt, snow, ice, etc. You must not lengthen, shorten or put a kink in the antenna cable. Do not remove the plug during the installation. If the antenna is painted the same colour as the vehicle, this may have an adverse effect on the reception, especially if paints containing a high percentage of metal are used. We assume no guarantee that the antenna will operate properly after it has been painted. On notchback vehicles, attach the antenna to the boot lid using the mounting brackets. Depending on the thickness of the metal, use the corresponding headless screws, Fig. On estate and hatchback cars, affix the antenna to the roof with its magnetic foot, Fig. For a roof mount, remove the mounting brackets. Use the adhesive strips enclosed to cover the screw holes, Fig. For estate and hatchback cars, lay the antenna cable along the rain gutter downwards and into the interior of the vehicle. Any obstacles near the antenna, such as roof racks or bicycle carriers, may have an adverse effect on or even obstruct satellite reception. Route the antenna cable into the interior of the vehicle and connect the plug on the antenna cable with the antenna jack on the basic unit. It is advisable to remove the antenna from the roof when driving through a car wash. If the GPS antenna is mounted inside the vehicle, there is no guarantee that the system will function correctly. Fig. 7 The display is mounted directly on a console (telephone console) with the ball joint. 8 The display is mounted using the gooseneck 7 612 001 204 and the ball joint. It is necessary to remove the back panel of the display first. Drill a 10-mm hole at the mounting location to accommodate the wiring and lay the wiring without subjecting it to any tensile strains or other loads. 9 1 Unscrew the four screws on the back of the display and remove the rear panel. 2 Pull out the plugs carefully and push them through the mounting base. 3 Then use the mounting material you require. Installing the speaker Install the speaker used for the spoken driving recommendations in the footwell of the vehicle. [. . . ] For four-wheel drive cars, on the lefthand rear wheel. In order to mount the wheel sensor and the magnetic strip, the vehicle must be jacked up. Always observe the safety instructions provided by the automotive trade!Offset Y: Set angle: Twisting angle: Length of the metal holder: The free-standing length must be kept as short as possible (max. [. . . ]