User manual BLAUPUNKT ODENSE AR 28

[. . . ] 2 Display for frequency range frequency memory bank channel preset 4 lo · m Changing the search tuning sensitivity for FM stations Io lit up in the display indicates normal sensitivity for the station search function. Io not lit up in the display indicates high sensitivity for the station search function. m lit up indicates manual station fine tuning. Added feature: Switch over from stereo to mono: Press lo · m for longer than 2 seconds and release. [. . . ] 5 ARI (traffic messages) When ARI is visible in the display, you are able to tune into only those radio stations which broadcast traffic messages. 6 1- 5 For storing and recalling radio stations Station selection automatic or manual ("m" in display). Switch over by pressing lo · m 4 9 PORTUGUÊS ESPAÑOL 3 SVENSKA stereo manual fine tuning sensitivity (station search) NEDERLANDS 8 TONE Adjust tone. more bass more treble ITALIANO 7 FM·T (frequency modulation) Switch for the FM memory banks I, II, III and "T" (Travelstore) - for storing and recalling the six nearest, strongest station signals. Store "T": Press FM·T until the search begins in the display. Recall "T": Press FM·T until T appears in the display. Then press the station button quickly and repeatedly if necessary. FRANÇAIS ENGLISH DEUTSCH Legend Important information Traffic safety As the driver of a motor vehicle, it is your responsibility to pay attention to the traffic situation at all times. Never use your car radio in a way that could distract you. Should the traffic situation become particularly demanding, we would advise you not to use the radio. · Press FM·T for at least 2 seconds. The radio will search for the nearest FM stations and store them in the memory bank "T" (Travelstore). When the process has been completed, the first station will be set. If you wish, you can also store stations in the Travelstore memory bank manually. · · to tune in the station you Press want to store (automatically or manually). Recalling stored stations You can recall the stored stations by pressing the corresponding buttons. Press FM·T until I, II, III or T appears in the display. · Select the station by pressing the button 1-5, press repeatedly if necessary. Note: If you tune into a station which has already been stored, then the corresponding button preset and the memory bank will flash in the display for approximately 5 seconds. 11 PORTUGUÊS Warning beep Should you leave the reception area of the station you are tuned to, then you will hear a warning beep after approximately 30 seconds. If you should press a button preset for a station which does not broadcast the ARI signal, then you will also hear a warning beep. ESPAÑOL SVENSKA Switching the traffic messages (ARI) on and off If you want to switch the reception of traffic messages (ARI) on or off · Press ARI. ARI will light up in the display, when the reception is switched on. Now the radio will only pick up those stations broadcasting the ARI signal. NEDERLANDS ITALIANO · Press the button 1-5 and hold it. [. . . ] ARI will light up in the display, when the reception is switched on. Now the radio will only pick up those stations broadcasting the ARI signal. NEDERLANDS ITALIANO · Press the button 1-5 and hold it. First the station will be muted and then become audible again. The station has been stored in the memory bank. [. . . ]