User manual BLAUPUNKT PHOENIX CD 70 INSTALLATION INSTRUCTION

[. . . ] During operation of the unit, the set's side wall may heat up considerably. Be sure to keep all wires away from hot parts of the housing. in vehicles manufactured by Audi and VW , the 8-pin positive/negative connector provided in the car must not be connected to a Blaupunkt radio directly!Otherwise the permanent +12 V line will be short-circuited to ground, leading to serious damage of the radio's internal circuitry (burn-out of printed conductor). [. . . ] Otherwise the permanent +12 V line will be short-circuited to ground, leading to serious damage of the radio's internal circuitry (burn-out of printed conductor). Connection 1 In order to take advantage of the full car radio output and to avoid Incorrect electrical connections with ISO plugs in the vehicle, it is advisable not to use the vehicle-specific positive/negative connection for this car radio. Installation in vehicles with a standard DIN installation compartment measuring 182 x 53 mm, 165 installation depth and an instrument panel thickness of approximately 1 to 20 mm in the area of the tab fasteners, see Fig. Reach behind the car radio compartment and check to see which tab fasteners can be bent for the mounting bracket. 5 Positive/negative connection with connection line 7 607 884 093 . 6 Use the connection wiring included with the amplifier or the connection block 7 607 874 003. 7 LF = left front, RF = right front, LR = left rear, RR = right rear. 8/9 Use the connection wiring included with the CD player or the connection block. If necessary, also use cables 7 607 647 093 and 7 607 648 000. When using the IR remote control, QuickOut operation is not possible. Lay the negative line to a suitable ground, such as a chassis screw or the chassis itself. then strip the insulation and attach a cable lug (solder if necessary). Remove the paint of the ground contact surface and treat with graphite grease (important for a good ground connection). Brown / ground When connecting the positive line to terminal 15 of the fuse box (+12 V via ignition) behind the fuse, it will be possible to turn the system on and off via the ignition. Also, the unit will automatically switch off after one hour of playback time to avoid that the battery goes flat. This hour logic will not be activated when connecting the permanent +12 V line (terminal 30). Do not connect the vehicle's positive line !5 mm2 cross section to the battery (do not route close to vehicle harnesses). Connect the fuse box to protect the positive line and hook up to the positive terminal of the battery. If necessary, drill a hole into the splash wall and use a cable duct as required. [. . . ] 5 mm2 cross section to the battery (do not route close to vehicle harnesses). Connect the fuse box to protect the positive line and hook up to the positive terminal of the battery. If necessary, drill a hole into the splash wall and use a cable duct as required. The control wire is the switched positive output for external pieces of equipment such as a power antenna, maximum load < 150 mA. [. . . ]