User manual BLAUPUNKT RPC 250

[. . . ] If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to consult the dealer or an experienced radio/TV technician for help. You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment. Precautions · Carefully read this manual before using the unit. If you encounter any problems that are not covered in this manual, please consult the dealer where you purchased the unit or the dealer nearest to you. · Avoid installing the unit where it would be subject to high temperatures, such as in direct sunlight or a hot air stream from the heater, or where it would be subject to dust, dirt, or excessive vibration. [. . . ] The "LD" indicator appears in the display window. Pressing this button again will cancel this feature. BALANCE FADER 4. to activate the clock. Ignition-off Clock Call The display will illuminate showing the time and then automatically shut off after 5 seconds. Briefly press the DISP while the ignition switch is in the " OFF " position to activate. Display Selector Each time the DISP is pressed, the display window will change as shown below; · Radio mode Frequency and Clock. · CD mode Elapsed track time and clock. E-3 ENGLISH 1. Radio Reception Seek Tuning ENGLISH Preset Scan Tuning 1. 2. Press the AM Receiving the Memorized Stations to select the desired radio band. 1. Press the AM or FM to select the desired band. FM I FM II FM III or AM I AM II Press the or to tune in stations. Seek tuning automatically stops at a broadcasted frequency. When tuning to FM stereo broadcasting stations, the " " stereo indicator will light up in the display window. or FM 2. Press the . The unit will scan preset memory for the 12 stations from the AM I/AM II band or the 18 stations from the FM I or FM II and FM III bands. The unit will stop at each preset station for 8 seconds, before continuing to the next preset station. Press the 5/RPT again to cancel this feature. or FM to select the radio reception. Ejecting Discs Press the to eject the disc. Note I NEVER Insert 3-inch CD's. This unit is designed for playback of standard 5-inch CD's only. Do not attempt to use 3-inch CD singles in this unit, either with or without an adaptor, as damage to the player and/or disc may occur. The unit will turn-on automatically when a CD is inserted if the ignition switch is ``ON''. MIX Play Press the 4/MIX during CD mode. All the tracks on the current disc are played in random order. Press the 4/MIX again to cancel this feature. Playing a CD in various modes Track Search Press the or during CD mode. Track numbers appear in the display window. : Playback starts from the beginning of the next track. : Playback starts from the beginning of the current track. Press again to play the previous track. Tip/FYI During playback of a CD, the pie-shaped indicator spins. Cue / Review Press and hold the or during CD mode. Release when you have found the desired point. : To search backward. E-5 ENGLISH Press the during CD mode. [. . . ] Make sure the unit operates properly. RCA Line-out Jacks White (Left) Red (Right) External Amplifier Rear Speaker RCA Line-out Jacks (For Rear Speakers) · Connect a patch cable (not supplied) from the White (left rear channel) and Red (right rear channel) RCA line output jacks of the unit to the line input terminals of the external amplifier. E-7 ENGLISH Maintenance Replacing the Fuse ENGLISH If the fuse is blown, check the power connection first and then replace the fuse. If the fuse blows again under normal conditions, the unit may be defective. Removing the Unit Use the supplied release keys when you need to remove the unit from the car. Insert them into the unit as shown below. This will unlock the unit from the sleeve, allowing for removal of the unit. Back of the unit Notes Warning Use only a fuse with the specified amperage (10 A). [. . . ]