User manual BLAUPUNKT SAVANNAH CR127

[. . . ] FCC Warning The equipment has been tested and found to comply with the limits for a Class B device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and, if not installed and used in accordance with instructions, may cause harmful interference with radio communications. However, there is no guarantee that radio interference will not occur in particular installation. [. . . ] Connect the yellow (constant power) input lead to a source of constant battery power, preferably a terminal to an appropriate slot in the fuse box. Connect the red (turn-on power) input lead only after the other leads are connected. Be sure to connect the red lead to a positive (+) 12 Volt power terminal that is energized only when the ignition key is set to the on position or accessory position. Cover the ends of any unused leads with electrical tape. This will prevent them from touching the vehicle or each other and causing a short-circuit and damage to the radio or vehicle. Once the connections have been successfully made, you can begin to mount the unit. SPEAKER CONNECTIONS he unit's Dual-Level Fader allows you to fade between the front and the rear channels using either the front and/or rear speaker leads and/or the rear preamp outputs, providing you tremendous flexibility in configuring your speaker arrangement: · You can connect a speaker (regular, co-axial or tri-axial speakers or component speaker system, all hereafter referred to simply as "speaker") to each of the units' four pairs of speaker leads. · You can connect the 2 RCA preamp outputs to multiple external amplifiers and power multiple speakers or speaker systems through the amplifiers. (Blaupunkt amplifiers and speakers available separately). To add front preamp output, purchase Blaupunkt part 8 634 494 218. · You can use a either or both of these two methods. Connecting the Speaker Leads To prevent short circuits or serious damage to the unit and/or speakers: · Connect the speaker leads only as indicated in the wiring diagram. Disconnect the vehicle battery's negative terminal before making connections. · Only use speakers that have impedance ratings of 4 ohms or higher and have power-handling capabilities greater than the unit's stated power level. · The unit's internal amplifier is designed to handle a 4-ohm load on each pair of speaker leads. · DON'T connect two speakers to a single pair of speaker leads ("in parallel") unless both speakers 6 each have at least 8 ohms impedance. DON'T connect the left and right speaker leads to each other or to the same speakers. Attach the back of the unit to the mounting strap using the support stem bolt and hardware. Bend these tabs Dashboard 8 Mounting the Unit in a Japanese Car You may have difficulty mounting this unit in some Japanese cars that have ISO mounting features (side-bracket mounting systems). In this case, consult your Blaupunkt dealer. 1 Run a blade along the slits on the back of the front trim ring, unscrew the two side screws, and separate it from the unit. Save the trim ring and related hardware in case you ever want to install the unit in another vehicle. 2 Use the vehicle's own mounting hardware to attach the unit. 1 Slit 2 TOYOTA max. size M5x8 to dashboard/center console max. [. . . ] Tape Program Change · Automatic Change (Autoreverse): When the end of the tape is reached, the unit will automatically reverse direction and play the other side of the tape. · Manual Change: To manually reverse tape direction, press both PROG (program) Buttons (FR & FF) at the same time. · The change in direction and in tape program will be confirmed in the display ("1" or "2"). Fast Winding · To Fast-Rewind the tape, press the FR Button. [. . . ]