User manual BLAUPUNKT SHARK LINE A-RP T 02-M

[. . . ] BASS, SCAN) Display field 3: Active functions 0 m In* FA LD Stereo Cassette inserted CD changer connected Loudness Radio mode - Seek tuning sensitivity lo Cassette mode RPT - Repeat function - Dolby noise reduction lm Chanaer mode loptionaa RPT - Repeat function MIX - Tracks played at random Numeric and graphic representation of volume and audio settings DSC Permanent display for DSC programming. Graphic representation of the adjusted volume level. * CD changer all sold separately. 3 Contents Display . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Quick reference . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] "CASSETTE" will appear in the display. The tape will play in the direction "TAPE 1". If a tape is already inside, press SRC to select "CASSETTE" mode. The tape will play in the direction last selected. The number of tracks to be skipped will appear in the display and count down until the track selected has been reached. Press QD or cc I >> to stop the function. If you have activated "Radio Monitor ON", the unit will play the radio station last selected while the tape is winding. You can alter the Radio Monitor setting in DSC mode. Scan To scan all of the songs on a tape, press SCA. "SCAN" will appear in the display. All of the tracks on the tape in the tape deck will be scanned briefly one after the other. Press SCA again to switch the SCAN function off. CDs with a diameter of 8 cm or CDs manufactured in the shape of a mug, for example, are not suitable for use with this equipment. Using such CDs can very likely result in the destruction of the CD and the CD drive. We assume no responsibility for damages caused by using unsuitable CDs. After you have inserted the magazine, keep the door closed to prevent the magazine from becoming dusty or dirty. Ejecting CDs Open the door of the CD changer and press the eject button. Dolby n01s. e reduction system IS manufactured under licence by Dolby Laboratories Licensing Corporation. The word "Dolby" and the double D symbol are trademarks of Dolby Laboratories Licensing Corporation. CD playback l Use SRC to select the CD changer. Press SRC repeatedly until "CHANGER" appears in the display. CD playback starts with the first CD identified by the changer. Selecting a CD When CD playback starts, all active CD functions and the CD number or name will light up in the display. To change the display between CD Name, CD number, elapsed time indication and clock, press 0 during CD playback. 15 When at start of first track, unit goes to last track on same disc. Press the button repeatedly to skip several tracks. The number of the selected track will appear beside `7" (track). AIv A V The following options are available: - Mix all tracks of one CD ("MIX-CD") or Mix all tracks of all CDs ("MIX-ALL") in manner determined by the CD changer model. [. . . ] Make sure the receiver is firmly anchored (preferably at both front and back) and does not vibrate. Installing the Receiver in Most Dashboards This car receiver and its mounting bracket are designed for installation in vehicles with a standard DIN installation compartment measuring 182 x 53 mm, a 165 mm installation depth and an instrument panel thickness of approximately 1 to 20 mm in. Place the mounting bracket in the compartment and bend over all of the tabs possible. Your vehicle may also allow you to provide extra stability at the back of the receiver. Look at the wall behind the radio cavity to see if there is a small hole the size of the enclosed plastic plug, If so, screw it onto the treaded bold at the back of the receiver before pushing it into the mounting bracket. [. . . ]