User manual BLAUPUNKT TP DX-N BLACK IBERIA

[. . . ] 5 Blue button for switching the monitor on/off. 6 MODE button For adjusting the 16:9 picture format (Full / Normal / Cinema). 7 Right +/- rocker switch for adjusting the contrast. ; < : RC 09H remote control handset 9 ! [. . . ] This means that after you leave the reception area served by your preferred station (the system will tune into a different TMC station) and return to this reception area again later, this is the station that will be selected even if other TMC stations are available. This intelligent switching function means that the station indication may change frequently in the reception area as well. This ensures that you always receive all of the traffic information which is transmitted by the TMC stations within reception range. 45 Dynamic route guidance with TMC Selecting the TMC station with the car radio A TMC-enabled car radio is able to provide traffic information to the TravelPilot EX-V. The "Congestion" menu will appear. The TMC seek tuning function for the car radio will begin. The seek tuning function will stop at the first TMC station within reception range and the station name will appear next to the menu item. If you would like to select a different station, start TMC seek tuning again. Note If, during route guidance, you tune into a station on the car radio which does not transmit TMC data or if you leave the reception area of the TMC station, dashes will appear in the display in place of the station name. In this case it will not be possible to receive traffic information. If you want to receive traffic information, it will be necessary to start TMC seek tuning for the TravelPilot EX-V again. 46 3. Dynamic route guidance with TMC Calculating the route with TMC while route guidance is in progress The traffic messages are transmitted by TMC stations along with their regular programming. If a traffic message affects the route calculated, then a new route to the selected destination will be calculated automatically. When "Change route options" is marked, press OK . The "Change route options" menu will appear. The currently active route preset ("Short route", "Fast route" or "Optimal route") is indicated with a dot. The other active options are marked with a checkmark. Activating/deactivating route options 2. Move the selection bar to the option you want to alter. Press A checkmark will appear or disappear. Mark the The route is calculated taking the changed options into account. 49 Selecting route options Altering the route options while route guidance is in progress It is possible to alter the route options while route guidance is in progress in the "Settings" menu for route guidance. Press OK while route guidance is in progress. Select "Settings" in the selection menu. Press The "Settings" menu will appear. [. . . ] Before drilling the holes for the mounting screws, make sure that no damage will be done to covered wiring, the petrol tank or fuel lines!Make sure that the vehicle operating elements remain easily accessible and are not obstructed in any way (gear stick, hand brake, etc. )!Note: The "wide screen" monitor is equipped with an integrated infrared receiver. This means that the supplied receiver for the RC 09H does not necessarily have to be installed. Important installation information for the speedometer signal When connecting the speedometer signal, make sure to observe the following information: 1. [. . . ]