User manual BLAUPUNKT TP DX-N RECHNER M RTC

[. . . ] The navigation equipment is suitable for vehicles with: · 12 V battery power · Negative pole on the vehicle body Contents Safety precautions . . . . . . . . . . . . . . 2 Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Description . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Installation preparations . . . . . . . . . . . . . . . . . . . . 4 Important installation information for the speedometer signal . . . . . . . . . . . . 7 Connecting the speedometer signal . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 18 DX-N and RC 09H in the front . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Before inserting the TravelPilot, you have to make sure that the gyroscope is positioned horizontally (see Fig. The TravelPilot DX-N can be installed in the car radio compartment in the vehicle (installation depth 218 mm). You will need an installation bracket (order no. For vehicles without a DIN compartment, a universal equipment housing has been included (see Fig. Check to see which method of installation is required for the vehicle and, if necessary, use a vehicle-specific installation kit. If a tuner box or remote control is to be added to the TravelPilot at a later date, the connection wire included (8 604 492 522) could be installed at this point. When selecting an installation location, you must remember that the navigation unit has to be built into the vehicle body. Installation position: right / left slope to the rear min. +100° Positive connection Connect the navigation unit to continuous plus and the positive connection to the ignition. Lay the continuous plus wire (red) to the battery (do not lay the wire directly along any wire harnesses). Connect a fuse holder to protect the positive wire at a maximum of 30 cm from the vehicle battery (if necessary, drill a hole in the splashback and use the necessary wire bushing). Connect the switching plus wire (black) to terminal 15 on the fuse holder (plus is switched by the ignition) behind the fuse. Negative connection Screw the negative wire (brown) directly to the vehicle body. Scratch the contact points on the ground down to the metal and grease it with graphite grease (important for a good ground). Installing the GPS antenna Install the antenna according to the enclosed instructions. If the GPS antenna is installed inside the vehicle, there is no guarantee that the system will function properly. A fan has been built into the back of the unit to cool it when it overheats. To allow for sufficient air circulation, make sure that the air vents are not blocked. Use only the hole strips to attach the unit to the mounting bolt. Make sure that there is enough room to insert and remove the navigation CD. 5 Allgemeines Kurzanlei- Zieleingabe Touren Zielspeicher Einstellun- Anhang Installation Installing the display Safety instructions Never grease or oil the ball-and-socket joint. The monitor cable must be laid so that it is not subjected to any tensile strains or other loads. Do not mount the monitor within the inflation range of the airbags (on the driver's side, the passenger side or the side airbags) or where it might strike the head or knees of anyone in the vehicle in the event of an accident!Before drilling the holes for the mounting screws and wiring, make sure that no damage will be done to covered wiring, the petrol tank or fuel lines!Unscrew the four screws on the back of the display and remove the rear panel. Pull out the plugs carefully and push them through the mounting base. [. . . ] Now select the required test using the or button, press the OK button and follow the on-screen instructions. If the test was completed successfully, the menu item will be labelled with a tick. If an error occurs, an appropriate notice will be displayed. bracket and IR sensor (eye) 11 Allgemeines Kurzanlei- Zieleingabe Touren Zielspeicher Einstellun- Anhang What's included in the delivery 8 618 841 412 6 m of DC wire 8 618 841 988 4 m of speedometer wire 12 brown white 8 618 842 033 4. 5 m of back-up lights signal wire 8 604 492 513 0. 3 m of connection wire (compartment C1) blue yellow What's included in the delivery 8 604 492 514 0. 3 m of connection wire (compartment A) 8 606 590 212 Universal equipment housing 8 604 492 522 Tuner box / RC 09 connection wire 8 604 492 515 0. 3 m of connection wire (compartment B) 13 Allgemeines Kurzanlei- Zieleingabe Touren Zielspeicher Einstellun- Anhang What's included in the delivery TravelPilot DX-N 7 612 001 461 7 612 001 489 Navigation unit with integrated gyroscope and GPS receiver 8 604 492 513 0. 3 m of connection wire (compartment C1) 14 8 601 360 105 Operating unit incl. [. . . ]