User manual BLAUPUNKT TP E EXACT MP3 G/G TUERK

[. . . ] 5 mm2 ), install the SO +/- cable together with the universal power supply cable (available at your specialist dealer; P/N 7 607 884 093); see Fig. For this type of connection, first check whether you have passive or active loudspeakers installed in your car. active loudspeakers have an integrated amplifier , passive loudspeakers do not have an amplifier. For more information contact your car dealer or audio dealer. [. . . ] Use ISO cable (7 607 647 093) to prolong your wiring. If active loudspeakers are installed in your car, you can order the necessary adapter cable for various vehicles from your specialist dealer. The following section gives you a brief installation overview. What car radio components are installed in your car?Car radio, loudspeakers with amplifier (active) or without amplifier (passive), antenna with or without amplifier, power antenna, window antenna. What adapters are used for the existing car radio?Are there standard ISO connectors (which are compatible with your Helsinki car radio) or car specific adapters? what cross-section do the existing cables have?Vehicles without car radio Are loudspeakers and power cables installed in your car?What does an standard ISO connector look like?You must not connect your Helsinki car radio to an existing 8-pin +/- ISO connector in your car. Our warranty shall be vain if the connection is made inadequately. To prevent inadequate electrical connection in vehicles equipped with ISO connectors, use the universal ISO adapter cable (P/N 7 607 621 126) for constant power connection, negative connection, the positive connection via the ignition, illumination and +12V switching output for external components such as a power antenna. At present, the following vehicles with standard ISO connectors can be adapted using the universal ISO adapter cable: Alfa Romeo, Citroen, Fiat, Honda, Lancia, Mercedes, Peugeot, Porsche, Renault, Skoda. For all other car models with standard ISO connector use the car-specific adapter cable. Make sure that the existing car radio terminal in the your car is protected by a 10 A fuse (see Fig. The mounting sleeve included with this car radio is designed for installation in vehicles with standard DIN installation compartment measuring 182 x 53 mm, 165 mm installation depth and a dashboard thickness of 1 to 20 mm in the area of the tab fasteners (see Fig. Insert the car radio into the sleeve and check which tabs on the sleeve can be bent with the help of a screwdriver (see Fig. Insert all connectors into the chambers until the side catches engage. Place the car radio in the front of the sleeve and push it in gently on both ends of the sleeve until the left and right side springs snap into place (you will hear an audible click), see Fig. [. . . ] Do not push on the display, keys or switches!Insert the handles into the holes in the panel on the left and right side of the radio and push them in until you hear an audible click (the side springs unlock). Gently pull the unit out using both handles (see Fig. Note: Handles which have snapped into place can only be removed after you have pulled the radio out of the compartment. [. . . ]