User manual BLAUPUNKT TP E EXACT MP3 W/W P

[. . . ] 16 Installation/connection . . . . . . . . . . . . . . . . . . . . . . . . . . 16 Radio Section . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 18 Automatic Station Tuning . . . . . . . . . . . . . . . . . . . . . . 18 Manual Tuning . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Then briefly press one of the presets 1, 2, 3, 4, 5, 6. @ PS rocker switch (Preset Station Scan) Pressing this button briefly samples all memorized stations of the selected waveband (U I-III or T). A TREB (Treble) To adjust trebles. B BASS To adjust basses. C FAD (Fader) (front/rear volume): Adjust using the lever. D QuickOut handle To pull the car radio out of the compartment. Only possible with QuickOut car radios. 15 PORTUGUES ESPAGÑOL SVENSKA NEDERLAND ITALIANO FRANÇAIS ENGLISH DEUTSCH Important information What you need to know! Before starting to use your new car radio you should carefully read through the information on "Traffic safety" and "Anti-theft coding". To listen to the radio or cassette again, · insert the set into the compartment until it stops and move the handle back to the front panel. If the coding system is off, your set will be ready for operation. If the coding system is on, proceed as described under "Restart following interruption of power supply". Anti-theft coding The car radio comes standard with the code system deactivated. If the anti-theft coding system is on while the power supply to the unit is interrupted (e. g. theft, disconnecting the car battery), the set is electronically blocked. The first "0" will not be displayed. - Press preset button 1 until "000" appears in the display. - Press preset button 2 five times, "500" appears in the display. - Press preset button 3 twice, "520" appears in the display. - Press preset button 4 once, "521" appears in the display. To confirm the code number: Press the upper part of the rocker switch . Now it is essential to enter the correct code after the waiting period has elapsed (Cod in the display). If the radio is turned off before the waiting period has elapsed, then the waiting period restarts as soon as the radio is turned on again. Switching the code system off · · · · Turn off the radio. Simultaneously press preset buttons 1 and 4 and hold them down. "Cod" will appear in the display. Switching the code system on Precondition: The radio must be connected to permanent power. In order to switch the code system on: · Turn the radio off. · · Hold down the preset buttons 1 and 4 simultaneously. [. . . ] The display : indicates which preset button has been pressed. Activating a Stored Station If required, the memorised stations can be activated at a keystroke. For this, press the FM·T button ?This alarm tone can also be heard when pressing a preset button with no ARI station allocated to it. Switching the Alarm Tone Off a) Tune in another station providing traffic information: · · press rocker switch 2 or a preset button on which a traffic station is stored. Adjusting the Volume of Traffic Messages and the Acoustic Alarm This volume has been set ex factory. [. . . ]