User manual BLAUPUNKT TP E EXACT MP3 W/W S

[. . . ] 27 Warning . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 27 Optical indication of theft protection . . 27 KeyCard . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 27 Replacing a KeyCard . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Each time the car radio is switched on, the radio will be automatically set to stereo reception. Press the desired preset button and hold it down. The radio will be muted and will resume play after approximately 2 seconds. The activated preset button is indicated in the display. · ESPAGÑOL SVENSKA NEDERLAND ITALIANO FRANÇAIS ENGLISH DEUTSCH Note: Should you tune into a station which has already been stored, the corresponding preset button and the memory bank will start flashing in the display for a short while, if you have selected another memory bank. Recalling stored stations Sampling stations briefly with You can recall any stored station by pressing Radio Scan the corresponding preset button. · Press FMT or M·L to select the waveband. For FM, also choose the corresponding memory bank by pressing FMT until the desired bank is indicated in the display. · Briefly press the corresponding preset button. Starting with the currently played station, you may let the system sample the following ones one after another. Choose the desired SCANTIME in the DSC menu. To activate Scan: · Press PS/SCA for about 2 seconds. The sampled frequency or the station name starts flashing in the display. During the actual search process, "SCAN" is flashing. Switching the warning beep off a) Tune to another traffic program station: · · Press the rocker switch, or press a preset button with a station offering traffic information. Alternative: b) Switch off the priority for traffic announcements: Press TIM for 1 second. In the display, the "TA" indication goes out. You can reduce the beep tone volume to the pre-selected mute volume. · Automatic seek tuning start Prerequisite: Priority for traffic announcements is activated. If you leave the reception area of your traffic program while listening to a tape or disc or when having turned down the volume completely, the car radio will automatically tune into another traffic program station. If no such traffic program station is found within approximately 30 seconds, tape or disc reproduction will be interrupted and the system will send out a warning beep. To switch off the warning beep, proceed as described above. Adjusting the traffic message volume The volume of the warning beep and of the currently played or stored traffic message has been pre-adjusted at the factory. However, you can change this default setting using the DSC function (see "DSC programing - TA LEVEL"). NEDERLAND ITALIANO FRANÇAIS ENGLISH DEUTSCH Reception of traffic announcements with RDS-EON (Enhanced Other Networks) Traffic Memo (TIM) This set is equipped with a digital speech memory, allowing up to 4 traffic messages lasting a maximum of 4 minutes to be automatically recorded. As soon as "TP" is displayed, the system will record all incoming traffic announcements of the adjusted station. If the priority for traffic announcements is activated ("TA" lights up in the display), the set will also record the traffic messages of the traffic station program within the same radio network (see also "Reception of traffic announcements with RDS-EON"). [. . . ] The following CDs are selected in numeric order, their tracks are played at random. MIX MAG ­ All tracks of the CD magazine are played at random. Selecting the MIX function: · Press MIX until the desired function is briefly shown in the display. If MIX is on, "MIX" is shown in the lower right corner of the display. Alternatively: · Press DSC. [. . . ]