User manual BLAUPUNKT TP E1 W ITALY

[. . . ] 28 Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 28 Accessories . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 28 KeyCard theft protection system 29 Putting the unit into operation . . . . . . . . . . . . . . 29 Removing the KeyCard . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] · · Press the DSC button and select "LEARN KC" with / . · Press << or >>. The display will switch to "CHANGE". Be sure that "LED ON" is adjusted in the DSC mode. If required, please refer to chapter "DSC programming - LED". Switching off the flashlight The flashlight can be switched off by pushing in the KeyCard and lock. If you would like to deactivate the flashing tongue with general effect, adjust the relevant item in the DSC menu to "LED OFF". Care of your KeyCard In order to ensure that the KeyCard always functions correctly, it is important for the contacts to be free from any foreign particles. If necessary, clean the KeyCard contacts using a cotton swab dipped in alcohol. Turn On Message (T. O. M. ) Using the second KeyCard to be purchased at any specialised dealership, you can program the unit to display a selected "Turn On Message" after the set is switched on. Any specialised dealer with the proper equipment can program the desired text with up to a maximum of 48 characters onto the KeyCard. Each time you switch on your car radio using the second KeyCard, this text will appear in the display. 30 Using the SRC button you can switch between radio and tape operation. Tape operation is only available if a cassette is inserted. To switch to another source, · press SRC briefly. AF - Alternative frequency The AF (Alternative Frequency) function makes sure that the strongest frequency of the currently selected programme is always tuned in automatically. If several programmes of the broadcasting networks can be received, you can scroll through them in forwards direction pressing >>, or backwards using the << button, e. g. For this it is necessary that the stations have been tuned in at least once and that "AF" is active (lights up in the display). For this purpose, start automatic tuning, e. g. using Travelstore: · Press FMT or BND for 1 sec. ; the system starts to run through the frequency band. If "AF" does not light up, · press AF. This fulfils the requirements for selecting stations with << >>. Seek tuning Up Down << / >> Up/Down in short intervals (FM only, "AF" must be switched off) Manual tuning with << >> You can also tune in a station manually. Condition: AF and PTY must be switched off (i. e. the symbols do not light up in the display). If necessary, deactivate these functions: · Press AF or PTY briefly. 32 Changing the memory bank You can shift between the memory banks I, II and T in order to store stations and recall them later. The currently selected memory bank is indicated in the display. · Press the FMT or BND button as many times until the desired memory bank lights up in the display. · · The activated preset button is indicated in the display. 33 PORTUGUÊS ESPAÑOL Press and hold down the desired preset button until the radio resumes play after the muting (takes approximately 1 sec. , confirmed by beep). [. . . ] Use the rocker switch to select and adjust the functions described in the following. The display will show you the adjusted condition. AM ON / OFF (Montreux RCR 127) You can deactivate one or both AM bands (MW/LW) in order to reduce the number of bands for selection with BND. selectable: AM ON MW OFF LW OFF AM OFF ­ ­ ­ ­ all bands LW, FM MW, FM FM TA VOL To adjust the traffic announcement and beep tone volume from between 0 to 63. [. . . ]