User manual BLAUPUNKT TP E2 GRUEN/GRUEN SK

[. . . ] Congratulations on purchasing this high-quality car audio amplifier. We, as innovators in car hi-fi systems, have built a new range of VPA amplifiers (Class A/B) to provide you with entry to the discerning world of audiophile components. Exceptionally high power reserves and outstanding sound mean the new Blaupunkt Velocity Series amplifiers impart a live feel to the music in your car. A signal-to-noise ratio of over 100 dB, an extremely low distortion factor, very high damping factor, high-quality materials, selected components, first-class finish and cutting-edge technology leave nothing to be desired. [. . . ] Modern high-powered systems and high-quality loudspeaker configurations are capable of producing sound pressure levels exceeding 130 dB. We provide a manufacturer guarantee for our products bought within the European Union. You can view the guarantee conditions at www. De or ask for them directly at: Blaupunkt GmbH Hotline Robert-Bosch-Str. 200 D-31139 Hildesheim For additional information on the Blaupunkt product line visit our web site at: http://www. Do not connect loudspeakers to earth ­ only use the correct terminals as indicated. The cross section of the positive and negative cables must be at least 25 mm2. The positive cable between the battery and the amplifier must be protected directly at the battery using a fuse holder (100 amperes). Note: In the case of longer supply lines to the vehicle battery, a second battery can be installed alongside the amplifier in order to stabilise the voltage. this must be installed by a professional workshop. Velocity High End Reference Amplifier TP E2 GRUEN/GRUEN SK The amplifier is suitable for connection to car audio systems that are equipped with RCA connections. If the fuse needs to be replaced, never bypass/bridge the fuse and never replace it with fuse types that are designed for higher currents. The cross section of the positive and negative cables must be at least 25 mm2. Use cable grommets to protect cables against sharp-edged holes. Securely screw a standard 25 mm2 negative cable to an interference-free earth connection point (bolt connected to the car body, car body sheet metal) - though do not connect it to the negative terminal of the battery. Scratch the surface down to the bare metal at the point at which the earth contact is made and apply graphite grease. 5 The switching line must be connected when connection is carried out +12V using the RCA jacks or the loudspeaker jacks of the car radio. LEVEL control You can use the LEVEL control to adjust the input sensitivity of the Velocity power amplifier to the output voltage of your car radio's preamp output. When connecting a car radio produced by another manufacturer, you must adjust the input sensitivity in accordance with the information provided by the manufacturer. This gives you the convenience of controlling the bass level remotely (see Fig. If you want to use the remote control, the device must be operated with the low-pass filter activated (crossover switch set to position LP). iNPUT Preamp inputs for the right and left channels. [. . . ] Please also use high-quality Velocity RCA cables for this connection. LP / FLAT switch Before installing, adjust the crossover switch on the power amplifier to set the low pass filter (LP) or full range (FLAT). If you select the FLAT position, the full frequency response will be used at the output. Using the integrated crossovers is particularly useful in the case of multi-channel sound systems with a separate subwoofer. [. . . ]