User manual BLAUPUNKT TP E2 GRUEN/GRUEN TS

[. . . ] Sound-pressure levels of more than 130 dB can be achieved with modern high-performance systems and highquality loudspeaker configurations. You can also obtain further information on our Velocity Series at our Internet address http://www. Use the Blaupunkt ISO-Cinch Adapter for connecting to car radios with ISO connector. [. . . ] Use the Blaupunkt ISO-Cinch Adapter for connecting to car radios with ISO connector. The safety instructions of the car manufacturer (airbag, alarm systems, on-board computers, engine immobilizers) must be observed. With regard to accident prevention the Velocity power amplifier must be affixed in a professional manner. The mounting surface must be suitable for accepting the enclosed screws and must offer secure installation. When drilling holes please ensure that no car components are damaged (battery, cables, fuse box). A dry position should be selected for the installation location that guarantees sufficient air circulation for the cooling of the amplifier. use cable bushings at sharp-edged holes. Use loudspeakers with 1-2-4 ohm impedance. in the Full position the full frequency response at the output is used. The use of the integrated frequency divider is sensible particularly with multipath sound systems with separate subwoofer. To operate a subwoofer optimally and therefore to achieve the best sound it is necessary to decouple the frequencies in such a way that only the bass frequencies are fed to the subwoofer. In order to do this please select LPF and regulate the upper frequencies between 50 Hz and 250 Hz using the crossover frequency control switch. This causes each subwoofer to be decoupled in an optimum fashion. By selecting HPF the lower threshold frequency can be varied between 50 Hz and 250 Hz using the relevant crossover frequency controller. to achieve exact acoustic agreement of the frequency divider we recommend that you consult a Velocity dealer. The specifications of the loudspeakers used must be taken into account without fail when carrying out the fine adjustment of the frequency divider. [. . . ] By selecting HPF the lower threshold frequency can be varied between 50 Hz and 250 Hz using the relevant crossover frequency controller. to achieve exact acoustic agreement of the frequency divider we recommend that you consult a Velocity dealer. The specifications of the loudspeakers used must be taken into account without fail when carrying out the fine adjustment of the frequency divider. [. . . ]