User manual BLAUPUNKT TRAVELP. DX R52A OHNE CD

[. . . ] - Make sure you do not damage vehicle components when drilling any holes. - The cross sections of the positive and negative cables must not be less than 2. [. . . ] - The cross sections of the positive and negative cables must not be less than 2. - Incorrect installation may cause interference with electronic vehicle systems or your car radio. The final stage must be installed professionally for reasons of safety. The mounting surface must be suitable for the screws provided, and must provide firm support (see Fig. Fit a fuse in the amplifier power line no more than 30 cm from the vehicle battery, in order to protect the battery in the event of a short-circuit between it and the power amplifier. The amplifier's own fuse protects the amplifier itself, but not the car battery. You may have to alternate between finely tuning Gain control 1 and Crossover control 3 to optimise the sound. Booming bass with an exaggerated volume can be achieved by setting the crossover to a low frequency. The Phase control should be adjusted so that the bass blends as best as possible into the overall sound and is not heard as a distinct source. DX R52A OHNE CD with the bass control fully turned up and, if necessary, with the loudness turned on. Overamplification of the ACITVE WOOFER BOX caused by too high sensitivity setting 1 leads to distorded reproduction and can irreparably damage the loudspeaker. Before using the equipment, we recommend you set the controls to the following positions: Gain, position 1 at mi4 Riets plus-pol, ledningen 7 svart till bilens chassie och styrledningen 8 gul till bilstereons styrutgång (t ex för automatantenner och förstärkare). [. . . ] DX R52A OHNE CD with the bass control fully turned up and, if necessary, with the loudness turned on. Overamplification of the ACITVE WOOFER BOX caused by too high sensitivity setting 1 leads to distorded reproduction and can irreparably damage the loudspeaker. [. . . ]