User manual BLAUPUNKT TRAVEL PILOT 100 EAST

[. . . ] Long press: Starts the Travelstore function. CD·C button Activates CD mode, MP3 mode or CD-changer mode. Display button Radio/CD: Search downwards / Skip to the previous track. Navigation: Deletes an entered character. [. . . ] Storing your current position as a destination You have the option of storing your vehicle's current position as a destination in the destination memory. This feature is useful if you spot an interesting location during your journey and want to return to it some other time. Note: To ensure that your vehicle position can be stored as a position, a navigation CD must be inserted in the drive. To store your current position as a destination, 1 2 press the NAV button 1. Select the memory bank in which you want to store the position. To do so, press the NAV button 1 repeatedly until the memory bank (N1, N2, N3 or N4) that you want appears in the display. Press the button <. N1 POSI=ION TMC 3 4 The current position is displayed. Whilst the position is being displayed, press and hold down one of the 1 - 6 buttons > for longer than 2 seconds to assign the position to that button. B243, SCHÜ TZENWIESE NAV The position is entered into the destination memory. INTRODUCTION NAVIGATION RADIO CD / MP3 CD CHANGER SETUP APPENDIX 39 INTRODUCTION NAVIGATION RADIO CD / MP3 CD CHANGER SETUP APPENDIX 40 Navigation Starting navigation Once you have entered a destination, the destination address appears in the display. If you want to start a navigation session in order to be guided to this destination, 1 press the OK button ;. N1 DES=N TMC BERLIN [D] , BERLIN, UNTER DEN LINDEN NAV Route calculation After you activate navigation, the system will show a warning on the display for approx. Afterwards, the system starts calculating the route. Plus Point: The system loads the route fully into the navigation memory when it calculates and completes the route. CDchanger mode is only available if a CD changer is connected and operational. If you want to switch back to the navigation session display, 2 press the NAV button 1. Cancelling navigation To cancel an active navigation session, 1 press the ESC button =. If you are sure you want to cancel navigation, 2 2 press the OK button ; or press the ESC button = again. Note: The data for the current corridor remain in memory after you cancel navigation. This means you can navigate to the last destination again without having to insert the navigation CD-ROM. If you enter a new destination, the system might ask you to insert the navigation CD-ROM. if you do not want to cancel navigation, NAVI TMC CANCEL ROUTE GUIDANCE? NAV Dynamic navigation During dynamic navigation, the TravelPilot E1/E2 analyses digital traffic information messages and uses this information when planning the route. The system receives the traffic messages from TMC (Traffic Message Channel) stations. These are RDS stations that additionally broadcast their traffic messages in digital form. If the system is already receiving a TMC station, the TMC symbol will appear on the display. If you want to make a currently active navigation session dynamic, 1 press and hold down the NAV button 1 for longer than 2 seconds during the active navigation session. [. . . ] You will be required to drive a route of at least 110 yards (100 metres) to 550 yards (500 metres) at a maximum speed of 18 mph (30 km/h). Please note that you must drive along a route that has been measured as precisely as possible. 1 2 3 4 Mark and confirm the MANual CALIBration menu item. Use the menu knob : to enter the route length and then press the OK button ;. [. . . ]